14
OM00720 Continuum Manual Rev 2 010118
OPTIONAL FEATURES
– Heat or Heat/Massage Recliners
MASSAGE OPERATION
BUTTON DETAIL
OPERATING THE HEATER
Reference page 13 for instructions on how to operate the heater in the heat/massage recliner.
OPERATING MASSAGE
Uncoil the power cord on the back of the chair and plug it into any standard wall outlet. You will
find the massage buttons on the table of the chair. This will typically be the right table (while
seated in the chair) unless other options require it to be on the left side.
NOTE:
The heat and massage options can be used independently of each other.
MASSAGE FUNCTION:
The massage switch function is controlled by a repetitively
pressing the massage button. The first button push will turn on the massage light and it
will remain on through the button press cycle until the massage system is off.
BUTTON PRESS SEQUENCE
1.
Lower Zone, Low Intensity
2.
Lower Zone, High Intensity
3.
Full Back, Low Intensity
4.
Full Back, High Intensity
5.
System Off
NOTE: The massage system is set to turn off fifteen (15) minutes after the last button
push.
If the occupant wishes to continue using the massage simply repeat the above steps.
NOTE: If the lights on the switch are flashing, unplug the chair from the outlet and
check all of the connectors of the heat system. If a connector is unhooked reconnect
it, plug in the power cord, and check the switch again. If all connections appear ok
and the lights still flash, unplug your chair and contact Champion’s customer service.
This does not affect the basic functions of the chair.
TABLE
LIGHT
S
MASSAGE
BUTTON
HEAT
BUTTON
