![background image](http://html1.mh-extra.com/html/champion/4000-starting-watts-3500-running-watts/4000-starting-watts-3500-running-watts_owners-manual_2588706051.webp)
Disassembly & Cleaning Instructions
(Chinese)
1. Unplug the juicer.
2. Slide the deflector up and off of the restrictor.
3. Slide the funnel up and off of the feeding tube.
4. Remove the restrictor by rotating clockwise and sliding off of face of the body.
5. Remove the body assembly by rotating clockwise and sliding forward away from the motor assembly.
6. While holding the body assembly in one hand, push on the face of the insert which protrudes beyond the face of the body. The insert should be free from the
body. If insert becomes stuck, grab the insert’s top opening to pull the insert out from the back of the body.
7. Slide the auger forward and off of the motor shaft.
Caution: The cutting blades of the Grinding Auger are sharp so use a cloth or a paper towel to grip the auger.
8. Remove the o‐ring from the hub insert using fingers.
Note: Do not pry the o‐ring using a knife or other sharp object as this will damage the o‐ring.
9. Clean, dry and inspect the o‐ring.
10. Clean the hub and motor assembly using a soft damp cloth. Pat the surfaces dry using a soft dry cloth.
Note: Do not use anything abrasive as this may permanently scratch or dull the finish.
Gently towel dry gently or allow to air dry.
Caution: DO NOT SUBMERSE THE MOTOR ASSEMBLY IN WATER.
11. Put a light coating of olive oil or coconut oil on o‐ring and re‐assemble over the hub insert.
12. Clean the bottoms of the motor assembly feet to prevent build‐up of residue.
13. Brush or scrub and then rinse the parts and set aside to air dry or place in dishwasher for final cleaning.
Note: The screen of the screen insert requires additional brushing on the inside and outside to totally remove all particles. Clean the screen insert as follows:
14.
After rinsing the inside and outside of the screen insert to remove excess debris, use a brush on the inside front and while moving the brush axially forward
and backward slowly rotate the insert. Then brush the outside screen surfaces while water is flowing over the area. Repeat until all of the screen is clean.
15. Clean the auger using the brush provided. With the grinding auger, brushing of the cutting teeth may be required to remove all debris.
Note: Rinsing the auger may introduce some moisture into the hole at the rear of the auger. Store the auger vertically with its base end down until dry.
16. Do not reassemble until all of the parts are completely dry.
49