200914 - 4250W DUAL FUEL OPEN FRAME INVERTER
CONTROLS AND FEATURES
13
Control Panel
1.
Intelligauge
– Four mode digital meter for displaying voltage,
frequency (hertz), run time, and total run time.
2.
Economy Mode Button
– Enables/disables automatic idle
control.
3.
Low Oil Warning Indicator Light
– When ON, engine will
shut down and not run. Check oil level.
4.
AC Overload Reset Button
– Used to re-energize
receptacles after overload fault.
5.
LPG Inlet
– Used to connect LPG fuel source to generator.
6.
Parallel Outlets
– Used to parallel two inverters together for
increased power output. (parallel kit sold separately).
7.
Ground Terminal
– Consult an electrician for local grounding
regulations.
8.
Circuit Breakers (Push Reset)
– Protects the generator
against electrical overloads.
RECEPTACLES
A
z
12V DC, 8A (Automotive)
May be used to supply electrical power for
operation of 12 Volt DC, 8 Amp electrical loads.
B
t
120V AC, 30A RV (NEMA TT-30R)
May be used to supply electrical power for
operation of 120 Volt AC, 30 Amp, single phase,
60 Hz electrical loads.
C
A
(2×) 120V AC, 20A (NEMA 5-20R)
May be used to supply electrical power for
operation of 120 Volt AC, 20 Amp, single phase,
60 Hz electrical loads.
WARNING
Do not operate a device while it is plugged into the 12V DC
outlet. Prolonged exposure to engine exhaust can cause
serious injury or death. While charging a device do no place
on the exhaust side of the generator. Extreme heat caused
by exhaust can damage the device, and cause a potential fire
hazard.
2
3
4
6
5
7
1
A
C
B
8
Side Panel
1.
Fuel Selector Dial
– Used to turn on gasoline or propane
(LPG) fuel source, turn off the gasoline (fuel valve), and STOP
the engine.
1
