![background image](http://html.mh-extra.com/html/champion/100647/100647_operators-manual_2588420030.webp)
30
100647 - ChAiNSAw
STORAGE
STORAGE
–
Loosen the saw chain if the chain tension was adjusted during
operation. The saw chain will contract as the unit cools, which
could damage the unit if the chain is too tight.
–
Allow the engine to cool before storing.
–
Thoroughly clean the unit and inspect it for any loose or
damaged parts. Repair or replace damaged parts and tighten
loose screws, nuts or bolts.
–
Cover the guide bar and saw chain with the scabbard.
–
Never store a fueled unit where fumes may reach an open
flame or spark.
–
Lock up the unit to prevent unauthorized use or damage.
–
Store the unit in a dry, well-ventilated area.
–
Store the unit out of the reach of children.
NOTiCE
It is normal for bar and chain oil to seep from the unit when
not in use. Please take this into consideration when storing the
unit.
Long-term Storage (30 days or more)
1. Remove the fuel cap, tip the unit and drain the fuel into an
approved container. Reinstall the fuel cap.
2. Start the engine and allow it to run until it stalls. This ensures
that all fuel has been drained from the carburetor.
3. Allow the engine to cool. Remove the spark plug and put
5 drops of any high quality motor oil or 2-cycle oil into the
cylinder. Pull the starter rope slowly to distribute the oil.
Reinstall the spark plug.
Preparing the Unit for Use after Long-term
Storage
Remove the spark plug and drain all of the oil from the cylinder.
NOTiCE
Do not use fuel that has been stored for more than 30 days.
Dispose of old fuel according to federal, state and local
regulations.