100523 - 3100W PORTABLE INVERTER GENERATOR
STORAGE
23
4. Start and run the generator for 10 minutes so the treated
gasoline cycles through the fuel system and carburetor.
5. Turn engine switch to the “OFF” position and allow
generator to cool completely before continuing.
6.
Option 1: Drain Gasoline from Carburetor
6a. Turn the fuel valve to the “OFF”.
6b. Place inverter on blocks to allow appropriate gasoline
container or pan to slide under inverter.
6c. Remove back access cover.
6d. Using a Phillips screwdriver, rotate drain screw
counterclockwise (3) full turns. Gasoline will drain
through clear tubing out underneath the inverter. Make
sure draining gasoline empties into an appropriate
container.
6e. When gasoline stops flowing from the carburetor,
rotate drain screw clockwise until tight. Properly
dispose of the drained gasoline according to local
regulations or guidelines.
7.
Option 2: Run Dry
7a. Turn engine switch to the “ON” position and start the
generator.
7b. With the generator running, turn the fuel valve to the
“OFF” position and allow the generator to run until the
engine stops from complete fuel starvation. This may
take a few minutes.
7c. Allow generator to cool completely before continuing.
8. Remove the spark plug cap and spark plug and pour about
a tablespoon of oil into the cylinder.
9. Pull the recoil slowly to crank the engine to distribute the
oil and lubricate the cylinder.
10. Reattach the spark plug and spark plug cap.
11. Clean the generator according to
Cleaning the Generator
.
12. Store the generator in a cool, dry place out of direct
sunlight.
Long Term Storage (more than 1 year)
For storage over 1 year, the gasoline tank and carburetor must
be completely drained of gasoline.
1. Be sure all appliances are disconnected from generator.
2. Place inverter on blocks to allow appropriate gasoline
container or pan to slide under inverter.
3. Remove back access cover.
4. Turn the fuel valve to the ON position.
5. Using a Phillips screwdriver, rotate drain screw
counterclockwise (3) full turns. Gasoline will drain through
clear tubing out underneath the inverter. Make sure
draining gasoline empties into an appropriate container.
6. When gasoline stops flowing from the clear tube, rotate
drain screw clockwise until tight. Properly dispose of
the drained gasoline according to local regulations or
guidelines.
7. Turn the fuel valve to the “OFF” position.
8. Follow steps 8-12 according to
Short Term Storage
.
Removing from Storage
If the generator has been improperly stored for a long period
of time with gasoline in the gasoline tank and/or carburetor, all
fuel must be drained and the carburetor must be thoroughly
cleaned. This process involves technically advanced tasks.
For assistance please call our Technical Support Team at
1-877-338-0999.
If the gasoline tank and carburetor were properly emptied of all
gasoline prior to the generator being stored, follow the below
steps when removing from storage.
1. Be sure the engine switch is in the “OFF” position.
2. Add gasoline to the generator according to
Add Fuel:
Gasoline
.
3. Turn the fuel valve to the “ON” position.
4. After 5 minutes check the carburetor and air filter areas for
any leaking gasoline. If any leaks are found, the carburetor
will need to be disassembled and cleaned or replaced. If no
gasoline leaks are found, turn the fuel valve to the “OFF”
position.
5. Check engine oil level and add clean, fresh oil if needed.
See
Oil Specifications
for proper oil type.
