100523 - 3100W PORTABLE INVERTER GENERATOR
CONTROLS AND FEATURES
12
Control Panel
1.
Fuel Valve Knob
–
Used to open and close the flow of fuel
to the engine.
2.
Choke
– Used to start a cold engine.
3.
Engine Switch
– Used to put in START mode or STOP the
generator.
4.
Economy Mode Switch
– Enables/disables automatic idle
control.
5.
AC Overload Reset Button
– Used to re-energize
receptacles after overload fault.
6.
Output Indicator Light
– Remains ON during normal
operating conditions. Turns OFF when generator is
overloaded.
7.
Overload Indicator Light
– When ON generator is
overloaded and power to receptacles is cut.
8.
Oil Warning Indicator Light
– When ON engine will shut
down and not run. Check oil level.
9.
Circuit Breakers (Push Reset)
– Protects the generator
against electrical overloads.
10.
Ground Terminal
– Consult an electrician for local
grounding regulations.
11.
Parallel Outlets
– Used for parallel operation (parallel kit
sold separately).
RECEPTACLES
A
t
120V AC, 30A RV (NEMA TT-30R)
May be used to supply electrical power for
operation of 120 Volt AC, 30 Amp, single
phase, 60 Hz electrical loads.
B
C
(2x) 120V AC, 20A GFCI (NEMA 5-20R)
May be used to supply electrical power for
operation of 120 Volt AC, 20 Amp, single
phase, 60 Hz electrical loads.
C
z
12V DC, 8 Amp (Automotive)
May be used to supply electrical power for
operation of 12 Volt DC, 8 Amp electrical
loads.
1
2
3
4
10
5
6
7
8
9
A
C
B
9
11
*Warning: Do not operate a device while it is plugged into the 12V DC outlet.
Prolonged exposure to engine exhaust can cause serious injury or death. While
charging a device do no place on the exhaust side of the generator. Extreme
heat caused by exhaust can damage the device, and cause a potential fire
hazard.
