2/20/19
5
Champion Power Equipment, Inc.
ADJUSTING THE DRIVE CONTROL HANDLE CABLE
Make sure that the tension on the
self-drive cable is adjusted so it has
between 1/4-3/8" (6.4-9.5 mm) of
movement. This movement can be
acquired by measuring the distance
the engagement paddle moves from
its starting position and the point it
becomes taut and starts to move
the transmission adjustment lever.
If the slack is greater than 5/8" (16
mm), please adjust. Proper tension
is important because you will want
your snowblower to move forward
properly in heavy snowfalls.
While operating the snowblower, if the drive control lever is too loose, tighten the nut counter-clockwise
while at the same time rotating the bolt upward to reach the position of the nut.
ADJUSTING THE AUGER CONTROL CABLE
Make sure that the tension on the
auger control cable is adjusted so it
has between 1/4-3/8" (6.4-9.5 mm)
of movement. This movement can
be acquired by measuring the
distance the engagement paddle
moves from its starting
position and the point it becomes
taut and starts to engage the auger.
If the slack is greater than 5/8" (16
mm), please adjust. Proper tension
is important because you will want
your snowblower to maximize belt
life in heavy snowfalls.
While operating the snowblower, if the auger control lever is too loose, tighten the nut counter-clockwise
while at the same time rotating the bolt upward to reach the position of the nut.
If you have any questions regarding the previous procedure, please contact our technical department
Monday-Friday from 8:30 AM-5:00 PM PST at 877-338-0999.
Champion Power Equipment, Inc.
12039 Smith Ave.
Santa Fe Springs, CA 90670
Phone: 1-877-338-0999
Email: [email protected]
