2
C h a m p i o n P u m p C o m p a n y
, Inc • P.O. Box 528 • Ashland, OH 44805
Phone 419-281-4500 • toll free 800-659-4491 • fax 419-616-1100
Before installation, read the following
instructions carefully. Failure to follow
instruction and Safety information
could cause serious bodily injury,
death and/or property damage. Each
Champion pump is individually factory
tested to insure proper performance.
Closely following these instructions will
eliminate potential operating problems,
assuring years of trouble-free service.
• Risk of electric shock. To reduce risk of
electric shock, always disconnect pump
from power source before handling.
Lock out power & tag.
• Installation must be in accordance
with the National Electric Code and all
applicable state and local codes.
• Installation and servicing is to be
conducted by qualifi ed personnel.
• These pumps are NOT to be installed
in locations classifi ed as hazardous in
accordance with the National Electric
Code, ANSI/NFPA 70.
• Keep clear of suction and discharge
openings.
• Do not insert fi ngers in pump with
power connected.
• Always wear eye protection when
working on pumps.
• Ground Fault Circuit Interrupter (GFCI)
to be used with plug-in type power
cord.
• Do not us these pumps in water over
104˚F. Consult Power-Flo for high
temperature pump models.
• The Uniform Plumbing Code (UPC)
states that sewage systems shall have
an audio and visual alarm that signals
a malfunction of the systems that is
required to reduce the potential for
property damage.
• Pumps build up heat and pressure
during operation-allow time for pumps
to cool before handling or servicing.
• This pump is not intended for use in
swimming pools or water installations
where human contact with pumped
fl uid.
ALL
RETURNED
PRODUCTS MUST BE
CLEANED, SANITIZED,
OR RECONTAMINATED
PRIOR TO SHIPMENT,
TO INSURE EMPLOYEES WILL NOT
BE EXPOSED TO HEALTH HAZARDS
IN HANDLING SAID MATERIAL.
ALL APPLICABLE LAWS AND
REGULATIONS SHALL APPLY.
IMPORTANT!
Prior to installation, record Model Number, MFG Date, Amps, Voltage,
Phase and HP, from pump name plate for future reference. Also record the
Voltage and Current Readings at Startup:
1 Phase Models
3 Phase Models
Amps:
Amps L1-2:
Volts L1-2:
Volts:
Amps L2-3:
Volts L2-3:
Amps L3-1:
Volts L3-1:
Other brand and product names are trademarks or registered trademarks of their respective holders.
Alteration Rights Reserved. 8/10
General Safety Information