10
ENGLISH
RT10005
asseMbly
Your chipper-shredder requires some assembly. This unit
ships from our factory without oil. It must be properly
serviced with fuel and oil before operation.
If you have any questions regarding the assembly of your
chipper-shredder, call our help line at +44(0)1942-715-407.
Please have your serial number and model number available.
Unpacking
1. Set the shipping crate on a solid, flat surface
2. Carefully cut the shipping bands and remove lid of
shipping crate.
3. Locate all hardware before beginning assembly.
1) Install the Shredder Chute
1. Tip the chipper/shredder over and remove the bolts
shown in Pic.2. DO NOT turn the chipper/shredder
over once it is full of oil and gas. The oil and gas will
spill out.
For fixing the leg: 3pcs Bolt M8x20, 1pc Bolt
M8x200, 1pc Support Tube, 3pcs Washer Ø8, 3pcs
Locknut M8.
For fixing the wheel assembly: 2pcs Bolt M8x200,
2pcs Support Tube, 2pcs Washer Ø8, 2pcs Locknut
M8.
2. Attach the wheel assembly and the leg with the
bolts that were removed in Step 1.
2) Install the Handle
1. Place the handle on the hopper and line up all of
the holes. Secure it with flat washer (Ø8, 4pcs),
spring washer (Ø8, 4pcs) and bolt (M8x20, 4pcs).
(See Pic.3)
Make sure chutes are fully secured with all the holes
aligned and filled with bolts. If parts are damaged or
missing do not use the unit until replacement parts
have been obtained.
NOTE
3) Install the Chipper Chute
1. Place the funnel over the studs in the side of the
chipper/shredder and secure it with flat washer(Ø8,
3pcs), spring washer(Ø8, 3pcs) and locknut(M8,
3pcs). (See Pic.4).
