19
REV 71321-20130513
ENGLISH
71321
MAINTENANCE AND STORAGE
Storage
For short and long-term storage, please follow these
guidelines .
battery
This product is equipped with an automatic battery
charging circuit . The battery will receive charging
voltage when the engine is running . The battery will
maintain a proper charge if the unit is used on a regular
basis (about once every two weeks) . If it is used less
frequently, the battery should be connected to a trickle
charger or battery maintainer to keep the battery
properly charged . If the battery is not able to start the
engine, it can be started by manually pulling the engine
recoil cord . If the battery voltage is extremely low,
the charging circuit may not be able to re-charge the
battery . In this case, the battery must be connected
to a standard automotive style battery charger for re-
charging before it can be used .
Ignition switch should be in the “OFF” position
while pulling the recoil cord, and performing storage
maintenance steps .
NOTE
Engine exhaust contains odorless and colourless
carbon monoxide gas .
To avoid accidental or unintended ignition of the
product during periods of storage, the following
precautions should be followed:
– When
storing the pressure washer for short
periods of time make sure that the Ignition
Switch, the Fuel Valve and the Trigger Start
™
Switch are set in the
OFF position .
– When
storing the pressure washer for extended
periods of time make sure that the Ignition
Switch, the Fuel Valve and the Battery Switch
are set in the the the
OFF position and the
battery leads have been
disconnected from the
battery .
DANGER
Engine Stored for less than 30 Days
1 . Allow the engine to cool completely before storage .
2 . Clean engine according to the Maintenance section .
3 . To extend the fuel storage life add a properly
formulated fuel stabilizer to the tank .
4 . Ensure the fuel valve is in the “OFF” position .
Engines Stored for Over 30 Days
1 . Add a properly formulated fuel stabilizer to the tank .
2 . Run the engine for a few minutes so the treated fuel
cycles through the fuel system and carburetor .
3 . Turn the fuel valve to the “Off” position .
4 . Let the engine run until fuel starvation has stopped
the engine . This usually takes a few minutes .
5 . The engine needs to cool completely before cleaning
and storage .
6 . Clean the engine according to the maintenance section .
7 . Change the oil .
8 . Remove the spark plug and pour about 1⁄2 ounce
of oil into the cylinder . Crank the engine slowly to
distribute the oil and lubricate the cylinder .
9 . Reattach the spark plug .
Disconnect the battery
1 . Remove the protective cover from the black/negative
battery lead .
2 . Disconnect the black/negative lead from the black/
negative terminal on the battery and store the cap
screw (M5x10) and lock washer (M5) .
3 . Repeat steps 1-2 for the red/positive battery lead .
4 . Store the battery in a cool, dry place .
A Float Charger will maintain the battery condition
over long storage periods .
NOTE
Charge the battery
For pressure washers equipped with batteries for electric
starting, proper battery maintenance and storage
should be followed . An automatic battery charger with
automatic trickle charging capability should be used to
charge the battery . Maximum charging rate should not
exceed 1 .5 amps . Follow the instructions included with
the battery charger . The battery should be fully charged
at least once per month .
