REV 71321-20130513
12
71321
ENGLISH
ASSEMbly
Add fuel Cont’d.
Add fuel
1 . Use clean, fresh, regular unleaded fuel with a
minimum octane rating of 85 and an ethanol content
of less than 10% by volume .
2 . DO NOT mix oil with fuel .
3 . Clean the area around the fuel cap .
4 . Remove the fuel cap .
5 . Slowly add fuel to the tank . DO NOT OVERFILL .
Fuel can expand after filling . A minimum of ¼ in .
(0 .64 cm) of space left in the tank is required
for fuel expansion, more than ¼ in . (0 .64 cm) is
recommended . Fuel can be forced out of the tank as
a result of expansion if it is overfilled, and can affect
the stable running condition of the product . When
filling the tank, it is recommended to leave enough
space for the fuel to expand .
6 . Screw on the fuel cap and wipe away any spilled fuel .
Use regular unleaded gasoline with a minimum
octane rating of 85 .
Do not mix oil and gasoline .
Fill tank to approximately ¼ in . (0 .64 cm) below
the top of the tank to allow for fuel expansion .
DO NOT pump gas directly into the pressure washer
at the gas station . Use an approved container to
transfer the fuel to the pressure washer .
DO NOT fill fuel tank indoors .
DO NOT fill fuel tank when the engine is running or hot .
DO NOT overfill the fuel tank .
DO NOT light cigarettes or smoke when filling the
fuel tank .
CAUTION
Pouring fuel too fast through the fuel screen may
result in blow back of fuel at the operator while filling .
WARNING
Our engines work well with 10% or less ethanol
blend fuels . When using blended fuels there are
some issues worth noting:
– Ethanol-gasoline blends can absorb more water
than gasoline alone .
– These blends can eventually separate, leaving
water or a watery goo in the tank, fuel valve and
carburetor .
– With gravity-fed fuel supplies, this compromised
fuel can be drawn into the carburetor and cause
damage to the engine and/or potential hazards .
– There are only a few suppliers of fuel stabilizer
that are formulated to work with ethanol blend
fuels .
– Any damages or hazards caused by using
improper fuel, improperly stored fuel, and/
or improperly formulated stabilizers, are not
covered by manufacture’s warranty .
It is advisable to always shut off the fuel supply,
run the engine to fuel starvation and drain the tank
when the equipment is not in use for more than 30
days .
NOTE
