100680 - 27 iN. 2-STAgE SNOwbLOwER
MAiNTENANCE
29
Replace Auger Drive belt – Splitting The
Snowblower body (Option 2)
Tools required:
–
Size 10 wrench (included).
–
Size 12 wrench (included).
–
Size 13 wrench (not included).
To remove and replace your snowblower’s drive belt, proceed as
follows:
1. Remove the plastic belt cover (A) on the front of the engine by
removing two M6 × 16 bolts (B) (Fig. 38).
b
A
Figure 38
2. Pull out the R pin (Fig. 39).
Figure 39
3. Remove the lever from the discharge chute bracket (Fig. 40).
Figure 40
4. Unscrew the bolt of auger control wire (Fig. 41).
Figure 41
5. Remove the 2 bolts (20 mm/30 mm) holding the belt guard
(Fig. 42). Note the spring is loose at this point.
Figure 42
6. Unscrew six M8 nuts to separate the auger housing from the
base (Fig. 43).
Figure 43
