100434 - 24 iN. 2-STAgE SNOwbLOwER
iMPORTANT SAfETY iNSTRUCTiONS
5
4. If the unit should start to vibrate abnormally, stop the engine
and check immediately for the cause. Vibration is generally a
warning of trouble. Vibration typically indicates a mechanical
problem has occurred.
5. Stop the engine whenever you leave the operating position,
before unclogging the auger housing or discharge guide, and
when making any repairs, adjustments,
or inspections.
6. Before cleaning, inspecting or repairing any parts of
the snowblower ensure the auger has stopped moving.
Disconnect the spark plug wire and keep it away from the
plug to prevent accidental starting.
7. Before leaving the machine unattended, disengage all control
levers, stop the engine and remove the safety key.
8. Do not run the engine indoors. Exhaust fumes are dangerous.
9. Do not clear snow across the face of slopes. Exercise extreme
caution when changing direction on slopes. Do not attempt to
clear steep slopes.
10. Never operate the snowblower without proper guards, plates
or other safety protective devices in place.
11. Never operate the snowblower near glass enclosures,
automobiles, window wells, etc., without proper adjustment
of the snow discharge angle. Keep children and pets away.
12. Do not overload the machine capacity by attempting to clear
snow at too fast a rate.
13. Never operate the machine at high transport speeds on
slippery surfaces. Use care when reversing.
14. Never direct discharge at bystanders or allow anyone in front
of the unit.
15. Disengage power to the impeller when snowblower is
transported or not in use.
16. Use only attachments and accessories approved by the
manufacturer of snowblower (such as wheel weights,
counterweights, cabs, etc.).
17. Never operate the snowblower without good visibility or light.
Always be sure of your footing, and keep a firm hold on the
handles. Walk; never run.
18. Take all possible precautions when leaving the machine
unattended. Remove the engine safety key.
19. Keep all nuts, bolts and screws tight to be sure the equipment
is in safe working condition;
20. Replace worn or damaged parts for safety; Use only genuine
replacement parts and accessories.
21. This snowblower is not intended for use by persons
(including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
22. Be careful while working on the machine or clearing a
blockage in the auger or impeller to ensure that fingers and
hands do not become crushed or cut.
23. Do not touch hot engine components like the muffler, muffler
guard or engine block during operation of the snowblower as
they will cause burns.
Clearing a Clogged Discharge Chute
Hand contact with the rotating impeller inside the discharge chute
is the most common cause of injury associated with snowblowers.
Never use your hand to clean out the discharge chute.
To clear the chute:
1. SHUT THE ENGINE OFF!
2. Wait 10 seconds to be sure the impeller blades have stopped
rotating.
3. Always use a clean-out tool. DO NOT use your hands.
Maintenance and Storage
1. Check shear bolts, engine mounted bolts, etc., at frequent
intervals for proper tightness to sure the equipment is in safe,
working condition.
2. Never store the machine with fuel in the fuel tank inside
a building where ignition sources are present such as hot
water heaters, space heaters, clothes dryers or any open
flame sources. Allow the engine to cool before storing in any
enclosure.
3. Always refer to owner’s guide instructions for important
details if the snowblower is to be stored for an extended
period.
4. Maintain or replace safety and instructions labels, as
necessary.
5. Run the snowblower for one minute to clear out packed snow
and ice to prevent freeze-up during storage.
