100396 - 3400W DUAL FUEL ELECTRIC START INVERTER GENERATOR
OPERATION
20
NOTICE
When the fuel selector switch is in the 3 o’clock position, the
gasoline fuel valve is OPEN. To CLOSE the gasoline fuel valve,
turn the selector switch to the 12 o’clock position.
Starting the Inverter
CAUTION
If the ignition switch is held down in the “Start” position longer
than 5 seconds it could damage the starter.
NOTICE
The supplied 12V 7AH battery does re-charge while the engine
is running, but it is also recommended that the battery be fully
charged at least once per month.
NOTICE
When the battery switch is in the “ON” position, the switch
will light up if the battery is sending out a charge. If the switch
does not light up while in the “ON” position, check that the
battery connection is still good.
NOTICE
If the engine starts but does not continue to run make certain
that the generator is on a flat, level surface. The engine is
equipped with a low oil sensor that will prevent the engine
from running when the oil level falls below a critical threshold.
Gasoline
NOTICE
The generator will NOT START with gasoline without battery
charge or an appropriate connection.
1. Make certain the generator is on a flat, level surface.
2. Disconnect all electrical loads from the generator. Never start
or stop the generator with electrical devices plugged in or
turned on.
3. Turn the fuel selector switch to the “Horizontal” position.
4. Pull the choke out to the “CHOKE” position.
5. Push the battery switch to the “ON” position.
6. Push the ignition switch to the “ON” position.
7. ELECTRIC START: Press and hold the ignition switch to the
“START” position. Release as the engine begins to start.
If the engine fails to start within five seconds, release the
switch and wait at least ten seconds before attempting to
start the engine again.
GASOLINE
B
