Children operating or playing with a garage door opener
can injure themselves or others.
The garage door could
close and cause serious injury or death. Do not allow
children to operate the door control(s) or remote control
transmitter(s).
A moving garage door could injure or kill someone under
it. Activate the opener only when you can see the door
clearly, it is free of obstructions, and is properly adjusted.
WARNING
NOTICE: To comply with FCC rules, adjustment or modification of this
receiver and/or transmitter are prohibited, except for changing the code
setting or replacing the transmitter battery. THERE ARE NO OTHER
USER SERVICEABLE PARTS.
SECURITY
✚
Garage Door Opener
Smart (learn)
Button
Indicator
Light
+
+
3
2
1
Kg
Kg
1
3
8
7
5
1
3
8
7
5
33
Figure 2
Your garage door opener receiver and remote control
have been pre-set at the factory. The door will open when
you press the LARGE remote control push button. The
code between the remote control and the receiver
changes with each use, randomly accessing over 100
billion new codes.
Your
SECURITY
✚
opener will operate with:
• several
SECURITY
✚
remote controls utilizing up to
8 functions.
• one
SECURITY
✚
Keyless Entry System.
Follow the instructions below to program your opener to
match any additional remotes you may purchase. See
Accessories on page 38.
To Add A Remote Control
1. With the door closed, press and hold a button on the
remote to be programmed. See Figure 1.
2. Press and release the Smart (learn) button on the
opener panel, Figure 2. The indicator light on the panel
will begin to blink and the opener light will flash once.
3. Release the remote push button.
Test by pressing the remote push button.
To Add A Remote Control Using the Door Control
1. With the door closed, press and hold a remote control
push button. See Figure 1.
2. Press and hold the Light button on the door control.
3. Press and hold the door control push bar.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the Smart button on the opener panel for
6 seconds. The indicator light will turn on. Release the
Smart button when it turns off. All codes are now erased
from the opener. Then follow the steps above to
re-program each remote control.
To Control the Opener Lights
With
SECURITY
✚
transmitters, a remote push button
can be programmed to operate the opener lights without
opening the door.
1. With the door closed, press and hold the remote button
that you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener
lights should turn on or off but the door should not move.
Code programming instructions are also located on
the opener panel.
Receiver and Remote Control Programming
SECURITY
✚
Remote Control
Select a
Push Button
Figure 1
