6
ASSEMBLY STEP 1
Attach the Rail to the Motor Unit
To avoid installation difficulties, do not run the garage
door opener until instructed to do so.
•
Remove the two washered bolts mounted in top of
motor unit.
•
Align rail and styrofoam over sprocket. Cut tape from
rail, belt and styrofoam.
•
REMOVE STYROFOAM.
•
Insert washered bolts through the rail into the motor
unit. Tighten bolts securely.
Use only these bolts! Use of any other bolts will
cause serious damage to door opener.
•
Position belt over the motor unit sprocket.
ASSEMBLY STEP 2
Set the Belt Tension
•
By hand, thread the spring trolley nut on the threaded
shaft until it is finger tight against the trolley (Figure 1).
Do not use any tools.
•
Insert a screwdriver tip into one of the nut ring slots and
brace it firmly against the trolley (Figure 2).
•
Place a 7/16" open end wrench on the square
end. Rotate about 1/4 turn until the spring releases and
snaps the nut ring against the trolley (Figure 3).
This extends the spring for optimum belt tension.
Trolley
Threaded
Shaft
Spring/Trolley Nut
The Chamberlain Group, Inc.
Liftmaster Synchro Drive
Spring Trolley Nut Assembly
3/5/92 - 5/16 /92 - 5/21/92 - 6/2/92
6/11/92
Nut
Ring
Trolley
Threaded
Shaft
Nut Ring
Slots
Square
End
Nut Ring
Trolley
Nut Ring
Trolley
1" (2.5 cm)
1-1/4" (3.18 cm)
BEFORE
AFTER RELEASE
Figure 1
Figure 2
Figure 3
USE ONLY THIS
TYPE AND SIZE
BOLT
Washered Bolt
5/16"-18x1/2"
Rail
Hole
Sprocket
Rail
Hole
To avoid SERIOUS damage to opener, ONLY use bolts/
fasteners mounted in top of motor unit.