6
201101-01
Note:
When first turned on wait about 1
1
/
2
minutes
for the circuitry to calibrate.
* resets to Auto Mode at dawn.
OPERATION
MANUAL MODE
Mode:
On-Time
Works: Day Night
Test
5 Seconds
x
x
Auto
1, 5, or 10
Minutes
x
Manual
To Dawn*
x
... back on.
1 Second
OFF
then
...
Manual mode only works at
night because daylight returns
the sensor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1,
5, or 10 position.
5. Increase or decrease the sensitivity as needed.
Too much sensitivity may cause false triggering
due to heat sources in the coverage area (see
Troubleshooting section).
6. Set the amount of ON-TIME you want the
light to stay on after motion is detected (1, 5,
or 10 minutes). The timer will reset as long
as there is motion present. Once motion has
stopped, the timer will time-out after the
selected amount of time.
9.1 m
(30 ft.)
1.8 m
(6 ft.)
Maximum
Maximum Range
Coverage Angle*
(Side View)
(Top View)
MANUAL MODE
AUTO
TEST
ON-TIME Switch at 1, 5,
or 10 minutes
MODE SWITCHING SUMMARY
Flip light switch
off for one second
then back on*
* If you get confused while switching modes, turn
the power off for one minute, then back on. After
the calibration time the control will be in the AUTO
mode.
150°
Rotating Sensor Head to Change Coverage Area
15
0°
150
°
Figure 8