7
Troubleshooting
LED INDICATORS FOR THE WI-FI HUB
WI-FI HUB STATUS
LED COLOR
LED STATE
Wi-Fi needs to be setup
Blue
Blinking
NO router communication
Green and Blue
Blinking
Wi-Fi setup active
Blue
ON
Communicating with router
Green
Blinking
Programming mode
Yellow and Green
Blinking
Normal operation
Green
ON
PROGRAM A DOOR SENSOR
To program a new sensor.
1. Use the MyQ App to add a new door sensor.
OR
1. Press and release BUTTON 1 for door 1 or BUTTON 2 for door 2 on the Wi-Fi hub. The
yellow LED on the Wi-Fi hub will turn off when successfully programmed.
2. Press the Test button on door sensor until the yellow LED on the door sensor turns on.
3. Press the Test BUTTON again on the door sensor and the Wi-Fi hub will beep once for
door 1 and twice for door 2.
The door sensor will not or is not programmed to the Wi-Fi hub.
• Press the Test button on the door sensor (the Yellow LED should blink). If the Yellow
LED on the door sensor does not blink, replace the battery, then replace the door
sensor. After replacing the battery, see
Program a Door Sensor
below.
The Wi-Fi hub will not operate the garage door opener.
• Ensure the garage door opener is compatible, see page 4.
• Follow the steps to program the Wi-Fi hub to the garage door opener, see page 4.
The remote control(s) will not program to the Wi-Fi hub.
• Verify the remote control is compatible. Visit www.myliftmaster.com for a complete list
of compatible accessories.
