background image

1

CONTENTS

PAGE

SAFETY INSTRUCTIONS . . . . . . . .1
CARTON INVENTORY . . . . . . . . . .2
TOOLS REQUIRED . . . . . . . . . . . .2
DOOR REQUIREMENTS . . . . . . . .2
PREPARE & TEST THE DOOR . .3-4
INSTALLATION . . . . . . . . . . . . . .5-6
CONNECT ELECTRIC POWER . . .6
ADJUSTMENT . . . . . . . . . . . . . . .7-8
INSTALL THE PROTECTOR
SYSTEM . . . . . . . . . . . . . . . . . . . . .9

WIRELESS PROGRAMMING .10-11
SPECIAL FEATURES . . . . . . . . . .12
SPARE PARTS . . . . . . . . . . . . . . .13
ACCESSORIES & WIRING . . . . . .14
DIAGNOSTIC CHART . . . . . . . . . .15
TROUBLESHOOTING . . . . . . . . .16
MAINTAINING YOUR OPENER . .17
CARE OF YOUR OPENER . . . . . 17
OPERATION OF YOUR OPENER 17
SPECIFICATION . . . . . . . . . . . . . .17
WARRANTY . . . . . . . . . . . . . . . . .18

The opener must not be used on a wicket
door (door within a door).

The Protector System

TM

must be used for all

installations where the closing force as
measured on the bottom of the door is over
400N (40kgf). 
Excessive force will interfere
with the proper operation of the safety reverse
system or damage the garage door.

After installation, ensure that the parts of
the door do not extend over public
footpaths or roads.

Install the wireless wall control (or any
additional wall control) in a location where
the garage door is visible, at a height of at
least 1.5m and out of the reach of children.
Do not allow children to operate push
button(s) or transmitter(s). 
Serious personal
injury from a closing garage door may result
from misuse of the opener.

Permanently fasten the Warning Labels in
prominent places, 
adjacent to wall controls
and manual release mechanisms as a
reminder of safe operating procedures.

Activate opener only when the door is in
full view, free of obstructions and the
opener is properly adjusted. No one should
enter or leave the garage while the door is
in motion.

Do not allow children to play near the door,
or door controls.

Disconnect electric power to the garage
door opener before making repairs or
removing covers.

KEEP THESE INSTRUCTIONS

WARNING

• Failure to comply with the following instructions may result in serious personal injury or property damage.

• Read and follow all instructions carefully.
• The garage door opener is designed and tested to offer safe service provided it is installed and

operated in strict accordance with the instructions in this manual.

These safety alert symbols mean WARNING : A possible risk to personal safety or
property damage exists.

NOTE: If your garage has no service entrance door, a CM1702 outside quick release must be installed.
This accessory allows manual operation of the garage door from outside in case of power failure.

Keep garage door balancedDo not let the
garage door opener compensate for a binding or
sticking

garage

door.

Sticking,

binding

or

unbalanced doors must be repaired before
installing this opener.

Do not wear rings, watches or loose clothing
while installing or servicing a garage door opener.

Frequently examine the door installation, in
particular cable, springs and mountings for signs
of wear, damage or imbalance. Do not use if
repair or adjustment is needed since springs and
hardware are under extreme tension and a fault
can cause serious personal injury.

To

avoid

serious

personal

injury

from

entanglement, remove all ropes, chains and
locks connected to the garage door 
before
installing the door opener.

Installation and wiring must be in compliance
with your local building and electrical codes.

The safety reverse system test is very
important. 
Your garage door MUST reverse on
contact with a 40mm obstacle placed on the floor.
Failure to properly adjust the opener may result in
serious personal injury from a closing garage
door. Repeat the test once a month and make
any necessary adjustments.

This appliance is not intended for use by persons
(including

children)

with

reduced

physical,

sensory or mental capablities, or lack of
experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.

This opener should not be installed in a damp
or wet space exposed to weather.

START BY READING THESE IMPORTANT SAFETY INSTRUCTIONS

Summary of Contents for Merlin Professional MR650





















Reviews: