2
1
3
4
Start with your garage door closed. Ensure that the door is clear of all
obstructions
Press and hold the Bottom Button on the remote
control until the blue LED stays ON solid
(approximately 15 seconds), then release the
button. (The blue LED will remain ON for 60
seconds)
Press and Hold the DOOR CODE button on the garage door opener
(Do not release the DOOR CODE button at this point).
Press and Release the remote control button you would like to program.
The Blue LED will commence blinking for 12 seconds.
Once the Blue LED changes to solid, release the DOOR CODE button
immediately
and Press and Release the remote button you are
programming.
The Blue LED will begin flashing once every three seconds. Wait until the
door begins moving, and
immediately
press the remote button again. The
coding process is complete and your remote should now be programmed
to the garage door opener.
You can repeat this process using the other remote button to program
another garage door opener.
ATA BRANDED OPENERS
These programming instructions are for ATA branded garage door openers.
Read through all steps before commencing, and become familiar with the
control buttons. Once the programming sequence has commenced its
important to continue from one step to another reasonably quickly. Time
between some steps is critical.
This is also a good time to view our Instructional videos on our website.
chamberlaindiy.com.au/universal or chamberlaindiy.co.nz/universal.
Blue LED
Bottom
Button
5
TEST
Test the remote control by pressing the button you programmed to control
the door. If the garage door opener does not activate, repeat the
programming steps, view the programming videos on
chamberlaindiy.com.au/universal or chamberlaindiy.co.nz/universal or
contact Customer Service AU: 1800 638 234 NZ: 0800 653 667
