2
1
3
4
Start with your garage door closed. Ensure that the door is clear of all
obstructions
Press and hold the bottom button on the
remote until the blue LED stays
solid (after approximately 15 seconds),
then release the button.
Press and hold the CODE SET button on the opener until the completion
of this step.
On the remote, press and release the remote button that you would like
to program. The blue LED on the remote will blink for up to 60 seconds.
Once the remote LED changes to solid blue release the CODE SET
button on the opener and press and release the remote button you are
programming.
The remote will begin flashing once every three seconds. Once the door
begins moving press the remote button again. Your remote is now
programmed to the garage door opener.
You can repeat this process using the other remote button to program
another garage door opener.
ATA BRANDED OPENERS
These programming instructions are for ATA branded garage door openers.
Note: Please read through all steps before programming the remote.
LED
Bottom
Button
5
TEST
Test the remote control by pressing the button you programmed to control
the door. If the garage door opener does not activate, repeat the
programming steps or visit chamberlaindiy.com.au/universal or
chamberlaindiy.co.nz/universal for additional instructions.
