TEST
Test the remote control by pressing the button you programmed to control
the door. If the garage door opener does not activate, repeat the
programming steps or visit chamberlaindiy.com.au/universal or
chamberlaindiy.co.nz/universal for additional instructions.
PROGRAMMING THE REMOTE
Start with your garage door closed. Ensure that the door is clear of all
obstructions.
Press and hold the bottom button on
the remote control until the blue LED
on the remote stays solid (approximately
15 seconds), then release the button.
Press and hold the LEARN button on your garage door opener for 2-3
seconds before releasing it (refer to the diagram on page 4 for
where the LEARN button may be located).
On the remote control, press and release the remote button you would
like to program. The blue LED will blink for up to 60 seconds. Once the
LED changes to solid blue press and release the button on the remote
that you are programming.
The remote will begin flashing once every three seconds. Once the door
begins moving press the remote button again. Your remote is now
programmed to the garage door opener.
You can repeat this process using the other remote button to program
another garage door opener.
LED
2
1
3
4
Bottom
Button
These are generic instructions for most garage door openers, however you
may need to refer to the instructions for your opener if your remote does
not program.
Note: Please read through all steps before programming the remote.
For ATA branded openers, please refer to the instructions on page 5.
3
