2
Assemble
The intercom must be
programmed to at least one
other intercom or Telephone
Interface Unit (OTIU) to
become a network or it can
be programmed into an
existing network.
Install 4 AA Alkaline batteries
(not provided). (Lithium
batteries recommended for
colder environments.)
Gate Access Panel (GAPLM)
Program
Step 1:
Set Dipswitch #1 to the UP position on
intercom.
Step 2:
Press the Learn button on the Passive
Intercom until a beep is heard.
Step 3:
Within 20 seconds, enter Master PIN Number
on GAPLM.
Step 4:
Press “05” and GAPLM will beep.
Step 5:
Press the Call button on the intercom.
Intercom will beep indicating programming is
successful.
Telephone Interface Unit (OTIU & MUOTIU)
Step 1:
On the phone connected to the OTIU, press
“**07” after hearing the dial tone. Hang up and Learn
LED will flash for 15 seconds.
Step 2:
Within 20 seconds, press and release the
Learn button on the intercom.
The OTIU will ring the telephone and Caller ID will
display “Unit Learned”.
NOTE:
To clear the memory on the OTIU, lift the
handset on the telephone and wait for a dial tone.
Press dial “**#8” and the telephone will respond with
a double beep. Memory is cleared.
Proceed to
Operation.
Flush Mount Intercom
Step 1:
Press and hold both buttons on the Flush
Mount Intercom for 3 seconds. The LEDs will flash.
Step 2:
Within 15 seconds, press the Learn button on
Door Intercom until a beep is heard. The Flush Mount
Intercom will beep indicating programming is
successful.
NOTES:
•
Program all other intercoms to the Flush Mount
Intercom, not the Door Intercom.
•
To clear Flush Mount memory, press and hold both
buttons. Two beeps will be heard and the channel
lights will begin to cycle. Continue to hold until a
third beep is heard (about 15 seconds). Ensure
other intercoms are not activated during this time.
Intercoms in the network that are on will signal
during the clearing process. Once memory is clear
the intercom can be programmed to a new network.
Proceed to
Operation
.
Portable Intercom
Step 1:
Press and release the Learn Button on the
Access Portable Intercom.
Step 2:
Within 15 seconds, press the Learn button on
Door Intercom until a beep is heard. The Portable
Intercom will beep indicating programming is
successful.
NOTES:
•
Program all other intercoms to the Portable
Intercom, not the Door Intercom.
•
To clear Portable Intercom memory, press and hold
Learn button, an initial beep will be heard. Continue
to hold until a second beep is heard (about 15
seconds). Ensure other intercoms are not activated
during this time. Intercoms in the network that are
on will signal during the clearing process. Once
memory is clear the intercom can be programmed to
a new network.
Proceed to
Operation.
Learn Button
Dipswitch
Block
