28
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
Meaning: This message will appear if the safety reversing sensors are out of
alignment, if they are blocked or if the wiring is disconnected. To clear message from
door control do the following:
• Check to see that area is clear between the safety reversing sensors.
• Check to see that the safety reversing sensors are not misaligned.
• Realign receiving eye sensor, clean lens and secure brackets.
• Verify door track is fi rmly secured to wall and does not move.
• Check to see that the safety reversing sensors’ wires are connected to the garage door
opener.
• If message has not cleared after the above checks, refer to message #2.
Meaning: This message will appear if the Safety Reversing Sensors are miswired. To
clear the message, do the following:
• Inspect the safety reversing sensor wires for a short (staple in wire), correct wiring
polarity (black/white wires reversed), replace/attach as needed.
• Disconnect all wires from back of garage door opener.
• Remove safety reversing sensors from brackets and shorten sensor wires to 1-2 feet
(30-60 cm) from back of each sensor.
• Reattach sending eye to garage door opener using shortened wires. If sending eye
indicator light glows steadily, attach the receiving eye.
• Align sensors, if the indicator lights glow replace the wires for the sensors. If the sensor
indicator lights do not light, replace the safety reversing sensors.
Meaning: This message will appear when the ‘LEARN’ button has been pressed on the
door control. Pressing the ‘LEARN’ button again will allow the user to program an
additional remote control to the opener.
Meaning: This message will appear when the ‘learn’ button has been pressed a
second time on the door control or anytime on the garage door opener. The garage
door opener is ready to program another remote control by simply pressing the remote
control button. Once the opener has ‘LEARNED’ the remote control, the worklight will
blink one time.
Meaning: This message will appear when the ‘Lock’ button has been pressed and held
for more than one second. This feature will disable the garage door opener from
receiving remote control signals. To exit ‘LOCK’ mode, press and hold the button for
more than one second.
Meaning: This message will appear when the ‘Language’ button has been pressed.
Pressing the button will toggle to the next language.
Meaning: This message will appear when the Motion Sensing button is pressed. The
motion detector will toggle on or off with each press of the button.
Meaning: Opener is running on battery power.
Meaning: Opener is running on battery power with full charge.
Meaning: Opener is running on battery power with low charge.
Meaning: Battery is beyond a recoverable condition.
Meaning: Battery charging from recent battery backup state.
Safety Sensors check alignment, blockage or
miswiring see owner’s manual
Safety Sensors malfunction check miswiring
see owner’s manual
Learn remote control press LEARN button to
confirm
Learn mode press remote control button to
program remote
Lock mode remote control locked out press
LOCK button to enable remote
English, Français and Español
Motion sensing on
Motion sensing off
Battery backup enabled
Battery backup enabled
Battery bad replace battery now see owner’s
manual
Power restored battery recharging
Battery low
Battery backup enabled
The following messages are contained within the Smart Control Panel
®
and may appear during the operations of the garage door opener:
Operation
Smart Control Panel
®
Messages
