5
INSTALLATION STEPS
9
FOR RIGHT HAND INSTALLATIONS
•
Ensure that the opener position jumper (wire connector) is
installed (refer Section 7).
• Place the opener in manual release mode (refer Section 11).
• Open the roller door fully. For safety, tie a rope around the door
(as shown).
• Mark the position of the door axle on the right hand door bracket.
• Carefully remove the U-bolt on the right hand side, checking that
the spring tension inside the roller door is not being released.
• You will need assistance for the following steps. To safely
support the door slide or lift the door axle clear of the door
bracket, supporting the door weight with a door stand or similar
device. Then slip the door opener over the door axle.
NOTE: The forks should engage either side of the support
spoke.
• Direct clamping method (refer fig 1): Place the opener and
door axle onto the door bracket in the position that the door axle
was originally. Clamp the opener to the door axle through the door
bracket with the bracket plate, 8mm bolts and nuts (supplied).
Tighten sufficiently to fasten the opener firmly to the axle i.e.
25Nm-28Nm.
• Remove any ropes used.
• Independent clamping method: If the side room exceeds
95mm, clamp independently to the door axle as illustrated in
section 3 (fig A) using 2 separate clamps.
FOR LEFT HAND INSTALLATIONS
•
Ensure that the opener position jumper (wire connector) is
removed (refer Section 7).
• Place the opener in manual release mode (refer Section 11).
• Open the roller door fully. For safety, tie a rope around the door
(as shown).
• Mark the position of the door axle on the left hand door bracket.
• Carefully remove the U-bolt on the left hand side, checking that
the spring tension inside the roller door is not being released.
• You will need assistance for the following steps. To safely
support the door slide or lift the door axle clear of the door
bracket supporting the door weight with a door stand or similar
device. Then slip the opener over the door axle (as shown).
NOTE: The forks should engage either side of the support
spoke.
• Direct clamping method (refer fig 2): Place the opener and
door axle onto the door bracket in the position that the door axle
was originally. Clamp the opener to the door axle through the
door bracket with the bracket plate, 8mm bolts and nuts
(supplied). Tighten sufficiently to fasten the opener firmly to the
axle i.e. 25Nm-28Nm.
• Remove any ropes used.
• Independent clamping method: If the side room exceeds
95mm, clamp independently to the door axle as illustrated in
section 3 (fig A) using 2 separate clamps.
Ensure that the U-bolt on the left hand (non opener) side of
the door is secure
.
Ensure that the U-bolt on the right hand side (non opener)
of the door is secure.
fig 1
Rope
SAFETY CHECK!
Are all brackets and door
fastenings tightly secured?
YES: proceed to the next
step
NO: tighten any loose
fastenings before
proceeding
fig 2
