9
INTRODUCTION
PRE-INSTALL
NETWORK
WIRING
ACCESS CONTROL
INSTALL
4
Mount the Bracket
1. Install an electrical box in the desired mounting location.
NOTE
: Use 4" square electrical box (minimum of 1 1/2" deep) with a single-gang plaster ring. Use Wiremold
®
V5744S or
BW35 for surface-mount installations.
2. Remove the bracket from the back of the CAP2D.
3. Mount the bracket to the electrical box.
4. Run all wiring to the electrical box.
5. Once all the wiring is completed, position the CAP2D in the bracket and secure it at the bottom with the provided screw.
Bracket
Electrical Box
