TO
PRESS
R ING
LEARN
LEARN
LEARN
Top Cover
9V Battery
Bottom Mounting Hole
Battery Cover
© 2007, The Chamberlain Group, Inc.
114A3448B
All Rights Reserved
The battery should produce power for at least one year.
Replace when the keypad illumination becomes dim or it
doesn’t stay on after a keystroke.
Dispose of old battery properly.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
KEYPAD TO INDOOR RECEIVER
CAUTION
: Pressing the learn button for more than 6 seconds will clear all the learned keypads.
The keypad can also be programmed to the gate operator using a 4-digit PIN entry code. Refer to your gate operator manual.
TO
PRESS
R ING
LEARN
LEARN
LEARN
LEARN
1
Push
“Press to Ring”
on the
keypad cover.
Push “
Press to Ring
” on the
keypad cover within 30 seconds.
Repeat operational test to verify.
Press and release the learn button
on the back of the indoor receiver.
The gatebell will ring.
Press remote control button to open
the gate.
PRESS
RIN
G
TO
PRESS
RING
TO
LEARN
LEARN
2
PRESS
RIN
G
TO
PRESS
RING
TO
LEARN
LEARN
1
TO
PRESS
R ING
LEARN
LEARN
LEARN
2
TO
PRESS
R ING
LEARN
LEARN
LEARN
3
NOTE:
Two people will be needed to properly test the gate doorbell.
Learn Button
PROGRAMMING
OPERATIONAL TEST
THE KEYPAD BATTERY
WALL MOUNTING
Plug power adapter into receiver.
Plug into outlet.
TO
PRESS
R ING
LEARN
LEARN
LEARN
LEARN
1
TO
PRESS
R ING
LEARN
LEARN
LEARN
2
TO
PRESS
R ING
LEARN
LEARN
LEARN
TO
PRESS
R ING
LEARN
LEARN
LEARN
5
4
Screw antenna into receiver. Determine
location for indoor receiver.
Mounting Holes
Insert remote control into receiver.
TO
PRESS
R ING
LEARN
LEARN
LEARN
6
Mark and drill pilot holes using 1/4"
drill bit.
Insert drywall anchors.
Position receiver on screw heads.
Drywall
Anchors
Wall
TO
PRESS
R ING
LEARN
LEARN
LEARN
3
Wall
Screw
Install mounting screws, allowing
1/8" (3.2 mm) to protrude above
surface.
INSTALLATION • MOUNT RECEIVER
FOR SERVICE DIAL OUR TOLL FREE NUMBER: 1-800-528-9131
2 1/8" (5.4 cm)
STOP
The included keypad is learned
to the receiver at the factory.
Follow the next steps to learn
replacement or additional
keypads only.
