22
INSTALLATION STEP 6
Install the Door Control
Locate the door control within sight of the door at a minimum
height of 5 feet (1.5 m) where small children cannot reach, and
away from all moving parts of the door and door hardware.
1. Strip 7/16" (11 mm) of insulation from one end of the bell wire.
Connect it to the two screw terminals on the back of the door
control by color: white wire to 2 and white/red wire to 1.
2. Remove the cover from the Lighted Door Control. Fasten the
Lighted Door Control Button securely with 6ABx1-1/2" screws.
If installing into drywall, drill 5/32" holes and use the anchors
provided.
3. Run the bell wire up the wall and across the ceiling to the
motor unit. Use insulated staples to secure the wire in several
places. Do not to pierce the wire with a staple, creating a short
or open circuit.
4. Receiver quick-connect terminals and the antenna are located
on the back panel of the motor unit. Position the antenna wire
as shown.
5. Strip 7/16" (11 mm) of insulation from end of bell wire.
Connect the bell wire to the quick-connect terminals as follows:
white to white and white/red to red.
NOTE:
When connecting multiple door controls to the opener,
twist same color wires together. Insert wires into quick-connect
holes: white to white and red/white to red.
6. Use tacks or staples to permanently attach the entrapment
warning label to the wall near the door control, and the manual
release/safety reverse label in a prominent location on the
inside of the garage door.
WIRING INSTRUCTIONS FOR ACCESSORIES
The Protector System
®
: To opener terminals: White to White and
Black to Grey.
Outside Keylock Accessory connections: To opener terminals:
Red/white to Red and White to White.
Dry Wall Anchors
Insulated
Staples
6ABx1-1/2" Screw
Lighted Door Control Button
HARDWARE SHOWN ACTUAL SIZE
Red
Black
White
To release or insert wire,
push in tab with
screwdriver tip
Door Control
Connections
11 mm
7/16"
Strip wire 11 mm (7/16")
To prevent possible SERIOUS INJURY OR DEATH from
electrocution:
• Be sure power is not connected BEFORE installing door
control.
• Connect ONLY to 24 VOLT low voltage wires.
To prevent possible SERIOUS INJURY OR DEATH from a
moving gate or garage door:
• Install door control within sight of garage door, out of reach
of children at a minimum height of 5 feet (1.5 m), and away
from ALL moving parts of door.
• NEVER permit children to operate or play with door control
push buttons or remote control transmitters.
• Activate door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep garage door in sight until completely closed.
NEVER permit anyone to cross path of closing gate or
garage door.
Bell Wire
Lighted Door
Control Button
Terminal Screws
Bell Wire
RED
WHT
-1
-2
Lighted
Door Control Button
Back Panel
Quick-Connect Terminals
Antenna
