Challenger
Optics.com
Wavelength Specific Optical Testing and Measurement Equipment
Challenger
Optics.com
Wavelength Specific Optical Testing and Measurement Equipment
Chapter 4.0 - Sweep Mode Operation
/ 07
Chapter 4.0 - Sweep Mode Operation
/ 08
SWEEP MODE OPERATION
Touch the step size indicator to cycle
through step sizes until the desired
step size is displayed. Step size is
displayed in the unit of measure
that is selected by touching the laser
output in the center of the display.
Available step sizes are 0.4, 0.8 and
1.6nm for wavelength, 50, 100 and
200GHz for frequency, and .5, 1 and
2 for channels.
Touch the power value and a
numeric keypad will be displayed.
Enter the desired power value
within the ranges set at the top of
the display and touch OK.
Touch the dwell time and a numeric
keypad will be displayed. Enter a
value from 2 to 60 seconds.
Continued
Touch and hold the high end slide
and drag it to the desired start
point for the sweep, or touch and
release the slide. The selection
arrows at the button of the display
will change to green and can be
used to step or snap the high
channel to position.
Touch and hold the low end slide
and drag it to the desired end
point for the sweep, or touch and
release the slide. The selection
arrows at the button of the display
will change to red and can be used
to step or snap the low channel to
position.
Touch the laser icon or the laser
start/pause to energize the. Touch
a second time to turn off the laser.
The Active output slide will move at
the selected step size between high
and low end channels (inclusive).
The sweep will return to the
beginning and continue until the
laser icon or laser start/paused is
touched again.
or
or
or
