The purpose
of this booklet is to provide assembly,
installation and operation information concerning the
herein described Residential Garage Door Opener and
related Accessory Products.
NOTICE
IT IS IMPORTANT THAT THIS INSTRUCTION
MANUAL BE READ AND UNDERSTOOD
COMPLETELY BEFORE INSTALLATION OR
OPERATION IS ATTEMPTED.
NOTICE
THE IMPORTANT SAFEGUARDS AND
INSTRUCTIONS IN THIS MANUAL CANNOT
COVER ALL POSSIBLE CONDITIONS AND
SITUATIONS WHICH MAY OCCUR DURING
ITS USE. IT MUST BE UNDERSTOOD THAT
COMMON SENSE AND CAUTION MUST BE
EXERCISED BY THE PERSON(S)
INSTALLING, MAINTAINING AND
OPERATING THE EQUIPMENT DESCRIBED
HEREIN. DO NOT USE THIS EQUIPMENT
FOR ANY OTHER THAN ITS INTENDED
PURPOSE - OPERATING OVERHEAD
GARAGE DOORS.
STANDARD FEATURES:
Digital Radio Controls:
This opener is equipped
with a pre-programmed transmitter to one of over
nineteen thousand private codes. The transmitter can
be re-programmed without difficulty using the
external operation buttons. The power head is easily
programmed to accept the transmitter signal.
(Page
Z
11)
Safe Finish™ Photosystem:
An invisible infrared
beam of light guards the door opening and reverses a
downward moving door if the beam is broken by a
stationary or moving object. The opener’s motor
control circuitry constantly monitors the Safe Finish
Photosystem for proper operation.
Alternating Action Operation:
The mechanical wall
push button functions in an Open/Stop/Close/Stop-
Reverse to Open mode in normal operation. (Page 15)
Manual Release:
A pull cord allows separation of the
drive mechanism and manual operation of the door when
desired, as in the event of a power failure. (Page 9)
Automatic Reconnection:
Once power is restored, or
automatic operation of the door is again desired,
initiating operation in the normal manner (Push Button,
Radio Control, etc.) will effect automatic reconnection
of the Manual Release Mechanism. (Page 9)
Sensing System:
A built-in sensing system detects
obstructions during door operation. If in the downward
(close) travel mode, the Opener will sense an obstruction
and reverse the direction of the door. In the open mode,
the opener will stop. Since all doors are different, the
Sensing System has independent adjustments for
customizing the level of force required for the normal
opening and closing of specified doors. ( Page 16)
Close Limit Switch:
In winter months it's common for
small pieces of ice or packed snow to be trapped under
the door. Ground swelling can also effect the close limit
setting of the opener. The opener’s Close Limit Switch
overrides the Sensing System during the last one inch of
closing travel and prevents the door from reversing if it
encounters an obstruction at this point.
Constant Contact To Close:
For utmost safety and
security, the standard operation mode requires constant
contact on the mechanical Push Button to close the door
if the Safe Finish™ Photosystem becomes misaligned or
if there is an irregularity in the wiring to the device. In
this mode of operation, a Radio Transmitter cannot be
used to close the door. (Page 18)
OPTIONAL FEATURES:
Keyless Entry System:
A tamper resistant outdoor
keypad, the optional Keyless Entry System permits entry
to the garage without use of key or radio transmitter.
Easily programmable, it accommodates a four digit PIN
code (10,000 possible codes). Lighted Buttons enhance
nighttime use.
STEP LADDER
TAPE
MEASURE
WOOD BLOCK
HAMMER
HACKSAW
SOCKET WRENCH
3/8” SOCKET
7/16” SOCKET
DRILL & BITS
SCREW DRIVER
1/2” OPEN END
WRENCH
LEVEL
TOOLS REQUIRED FOR INSTALLATION
PRODUCT FEATURES
7/16
3/8
SMALL SCREW
DRIVER (1/8” HEAD)
2
