F.352-KO/EH-3C DRILL/AUG 03
3-2
3.0 ACCESSORIES
3.4 HANDI-SHARP DRILL SHARPENER
Cat. No. 57100
The Handi-Sharp mounts on the edge of table or bench.
A dull hollow drill bit is placed in the holder, and the
cutting bit is pushed against the end of the hollow drill
until its spring bottoms out. The spring prevents exces-
sive force from being applied while sharpening. Turning
the handle while applying a hone produces a fine edge.
Item
Cat. No.
Replacement Cutting Bit
6469
Adapter for other style drill bits
57114
3.5 HOLLOW DRILL SHARPENER / CHIP REMOVER
For fast, easy drill sharpening and chip removal
CAUTION: Drills are sharp even after use. Be careful to keep edge
away from your body. To prevent personal injury and/or damage to
the drill, ALWAYS keep drills in protected area.
3.5.1 Using the Chip Remover
1.
CAREFULLY place a hollow drill in the holder sec-
tion as shown, and insert the holder (with drill) into
the chip remover end as shown.
(cut-away view)
(cut-away view)
NOTE: Chip remover is only for use with hollow drill diameters 3/
16” and larger
2.
Firmly tap the entire assembly on a solid surface
to remove the chips from the hollow drill.
3.5.2 Using the Drill Sharpener
1.
CAREFULLY place a hollow drill in the holder sec-
tion as shown, and insert the holder (with drill) into
the sharpener end as shown. Be very careful to
bring the drill and cutting tool together with out
bumping.
The cutting tool is made of GLASS
HARD material and may be chipped.
2.
USE CLOCKWISE ROTATION while maintaining
an even pressure, until the hollow drill is sharp-
ened (usually two or three turns). The cutting tool
seldom requires replacing, but when it does be-
come necessary, the bit can be ordered through
your Challenge Dealer (
Cat. No. 4952
).
