APR 2018
CMT-330TC Three-Knife Trimmer
4-4
4. Routine Tasks
rear lower door. The cut stick puller has a
finger hold and hook (Figure 4-6).
Figure 4-6. Cut Stick Puller
4. Hook the Cut Stick Puller over the right end
of the cut stick (Figure 4-7) with a finger in
the loop of the puller. Keep the Cut Stick
Puller in-line with the cut stick.
Figure 4-7. Pulling Cut Stick Up
5. Pull the Cut Stick Puller at a slight angle
(Figure 4-7) over the cut stick until the end
of the cut stick comes out of the table.
6. Remove the remaining cut stick from the ta-
ble by hand.
7. Inspect the cut stick for wear. It may be
used 8 times (twice on each surface) before
disposal. To use a surface twice, reinstall
the cut stick by turning it such that the end
that came out of the right end of the slot
goes into the left end of the slot. If a surface
has been used twice, rotate the stick to an
unused surface before reinstalling (Figure
4-8). If all (4) surfaces have been used
twice, replace the stick with a new one.
Figure 4-8. Cut Stick Rotation
8. Firmly press the new or rotated cut stick all
the way down into the slot. The top of the
cut stick should be flush with the table.
9. Securely close the upper rear doors.
4.5 Knife Change
WARNING
Changing knives can be very dangerous un-
less safety precautions are observed and ex-
treme care is taken when handling knives.
Keep handling of unprotected knives to an
absolute minimum. Have the scabbard
nearby and insert knife immediately. Warn
people of any unprotected knife.
WARNING
Knife changing is a ONE PERSON
OPERATION! More than one person chang-
ing a knife creates safety hazards.
WARNING
Even used knives are extremely sharp! Use
extreme care when handling new, re-ground,
and used knives.
WARNING
Disconnect and lockout power as described
in Section 1.6 Power Lockout Procedure on
page 1-4.
The knives may be removed or installed in any
order. The knives are located behind the doors
shown in Figure 4-9 and Figure 4-10.
Figure 4-9. Left and Face Knife Locations
Summary of Contents for CMT-330TC
Page 4: ...APR 2018 CMT 330TC Three Knife Trimmer iv Introduction Notes...
Page 28: ...APR 2018 CMT 330TC Three Knife Trimmer 1 24 1 Introduction NOTES...
Page 60: ...APR 2018 CMT 330TC Three Knife Trimmer 3 12 3 Operator s Guide NOTES...
Page 72: ...APR 2018 CMT 330TC Three Knife Trimmer 4 12 4 Routine Tasks NOTES...
