HELPLINE NO 08448012949
11
OrIgINaL INstructIONs
writing. Use this feature only with a shallow depth
of cut.
NOtE:
As the router rotates in a clockwise
direction always move the tool in a left to right
direction as you stand facing your work.
(See Fig.M, N)
When cutting an outside edge move the router
counterclockwise; and clockwise to cut an inside
edge.
12. fIttINg tHE cENtEr PIN aND
MakINg cIrcuLar cuts (see fig.P, Q)
The Center Pin allows you to make circular cuts.
·
Push the Center Pin onto the Parallel Guide
shaft of the Parallel Guide and fasten it in place
with the thumb screw.
·
Place the Center Pin against the material.
·
Set the required radius by adjusting the shaft of
the Parallel Guide and tighten the Parallel Guide
locking screws.
·
Fix router in required depth with lock lever.
·
Switch on the machine.
·
After releasing the Plunge Lock Lever, lower the
machine slowly.
·
Cut grooves, shoulders, etc at a steady rate of
feed, holding the machine with both hands.
·
When finished, raise the machine again.
·
Switch off the machine.
13. fIttINg tHE ParaLLEL guIDE (see
fig.r, s)
Before using the Parallel Guide you will need to
assemble the guide. Remove the two screws and
washers from the end of the two shafts and fit the
guide to the bars using the washers and screws
you removed. Tighten screws securely.
Insert the bars into the grooves in the base of the
router. Adjust the guide to the required cutting width
and tighten the two Parallel Guide locking screws.
NOtE:
a: washer
B: spring washer
c: screw
D: Parallel guide base
E: Parallel guide shaft
14. rOutINg wItH tEMPLatE guIDE (see
fig. t, u)
The Template Guide (18) enables template and
pattern routing on work-pieces.
Place the Template Guide over the hole in the
center of the base plate, and align the two through
holes in the bottom of the base plate with the
countersunk holes in the Template Guide. Fasten
the Template Guide with the nuts and screws
provided.
Fig.Q
Fig. R
Fig. S
Fig. T
Fig. U
Fig.Q
Fig. R
Fig. S
Fig. T
Fig. U
Fig. I
Fig. J
Fig. K
Fig. L
Fig. M
Fig. N
Fig. O
Fig. P
Fig.Q
Fig. R
Fig. S
Fig. T
Fig. U
