HELPLINE NO 08454 505299
12
ORIGINAL INSTRUCTIONS
Adjusting the Pendulum Stroke
The pendulum action can be adjusted with the
pendulum action switch (7), even during
operation.
Set the pendulum action switch (7) on one of
the following positions:
Position 0 = No oscillation
Material: rubber, ceramic, aluminum, steel
Note: For fine materials and clean cut,
thin materials (sheets)
Position 1 = minor oscillation
Material: plastic, wood, aluminum
Note: For hard materials
Position 2 = medium oscillation
Material: Wood
Position 3 = strong oscillation
Note: For soft materials and when sawing in
the direction of the grain
The best combination of speed and pendulum
action is dependent on the material to be
processed. We recommend always determining
the ideal settings by using a sample cut from a
piece of scrap
Adjusting the base (see fig.4)
The base ( 6) can be swiveled by ±45° for mitre
cuts.
Loosen the two bolts in the base (6) by using the
allan key supplied for the saw.
Slide the base back to disengage the incremental
lock and tilt the base (6) to the desired angle.
There are increments of 15 ° on the scale.
Fix the base by sliding it forward until the
incremental lock engages and tightening the
two bolts firmly.
Ensure that the base is set at 0°
when using the laser guide or the
line will not be true.
Sawdust Extraction device
With the air flow of the sawdust extraction
feature (14) the cutting line can be kept free of
dust and chips.
Switching on the sawdust blowing
device:
For cuts in materials with high removal rate,
such as in wood, plastic, etc., push the switch
(14) towards the vacuum connection.
Switching off the sawdust blowing
device:
For cuts in metal and when a dust extraction
system e.g vacuum cleaner is connected, push
the switch (14) towards the saw blade.
4
