Instructions
Instructions
Feeding out the cutting line
If the cutting line is worn you will need to feed
out more line.
1
While the line trimmer is off remove the cutting
line trimming blade protector (fig 10).
2
Hold the line trimmer above a firm surface and
switch on as described in this booklet.
3
Lightly bump the line feed button on the
firm surface.
4
The cutting line is fed out and the cutting line
trimming blade adjusts the cutting line to the
correct length.
5
If the cutting line is too short it will not feed
automatically in this case remove the spool
and spool cover as described in this booklet.
6
Pull the spool out of the spool cover.
7
A plastic band is fitted around the spool, to
remove it squeeze it at 90
o
to the slots and
remove it from the spool (fig. 11).
8
Find the ends of the cutting line and thread them
through the slots in the plastic band.
9
Slide the plastic band back over the spool,
making sure not to trap the cutting line
(fig. 12).
10
Thread the ends of cutting line through the
holes in the spool cover and push the spool
into the spool cover (fig. 13).
11
Make sure the spring is positioned in the back of
the spool and push the spool and spool cover
into the spool holder. The spool holder will click
into place.
1
Line up the ridges on the lower shaft with
the slots on the upper shaft. Slide the
lower shaft into the upper shaft until it
clicks into place (fig. 6).
2
Position the trimming attachment as
shown in fig. 7 for
grass
trimming
.
NEVER attach in reverse
direction as
shown in fig. 8, it would cause injury
.
3
When using the trimmer in edging mode
place the cutting head over the edge
and hold it so that it is just off the ground
(fig. 9). Walk slowly along the edge and
guide the trimmer so that it cuts off the
overhanging grass.
Warning!
When using the grass trimmer in
edging mode keep away from the cutting line
to avoid any flying particles given off by the
trimmer. The trimmer should only be used to
maintain original edges not create new ones.
4
To remove the cutting attachment
squeeze and hold the two ribbed clips
on the side of the lower shaft (fig. 6)
and pull the upper and lower shaft
apart until the cutting attachment is
free of the upper shaft.
fig. 6
fig. 10
Plastic
band
fig. 11
fig. 12
fig. 13
fig. 7
fig. 8
fig. 9
Attach the cutting attachment
Lawn
edge