8
Helpline No: UK 0151 649 1500 / IRE 189 094 6244
GB
Never attempt to remove the cuttings with the
blades running or to hold material you wish
to cut. Always switch off the device before
attempting to remove any jammed cuttings.
A
memory of inattentiveness when using the hedge
trimmer may result in serious injuries.
18.
Hold the hedge trimmer by the handled when
the blades are at a standstill, always close the
safety cover when transporting or storing the
hedge trimmer.
Handling the machine with care
will reduce the risk of injury from the blades.
19.
Keep the cable away from the cutting area.
Whilst you are working the cable may be covered
in the branches which means that you might cut
through it by accident,
20. Look in the hedge for concealed objects, such as
wire fences, before starting work.
21. If the connection lead has to be replaced, this
work must be carried out by the manufacturer or
one of its agents to prevent safety risks.
2. Items supplied (see Fig. 1)
- 1 hedge trimmer
- 1 cutter guard (7)
3. Layout (see Fig. 1)
1. Cutter
2. Hand
guard
3. Guide handle with switch button
4. Handle with switch buttons above and below
5. Cable strain relief clip
6. Power
cable
7. Cutter
guard
8. Impact
guard
Important! You must never use the hedge trim-
mer without wearing gloves.
4. Explanation of the sign (see Fig. 3)
1. Warning
2. Keep out of the rain and protect from getting wet.
3. Read the operating instructions before using for
the first time.
4. Pull the plug from the power supply immediately
if the cable gets damaged or severed.
5. Wear goggles and ear protection.
5. Technical data
Voltage
230-240 V ~ 50Hz
Power consumption
600 W
Cutting length
590 mm
Blade length
660 mm
Tooth spacing
20 mm
Cuts/min
3200/min
Sound power level LWA
96 dB(A)
Sound pressure level LPA
88,6 dB(A)
Vibration aw
3,3 m/s
2
Weight
4,0 kg
6. Mains connection
The machine can only be run on single-phase alter-
nating current with 230 V ~ 50Hz a.c. voltage. Before
you use the machine for the first time, check that the
mains voltage is the same as the operating voltage
shown on the machine rating plate.
7. Start-up and operation
Important! This hedge trimmer is designed for the
trimming of hedges, bushes and shrubs. If it is used
for any other purpose not expressly permitted by
these operating instructions there may be a risk of
damage to the hedge trimmer or serious injury to the
user. The hedge trimmer comes with a two-hand
safety switch. It only works if the switch on the guide
handle (Fig. 2 / Item 1) is pressed with one hand and
either the switch on top of the handle (Fig. 2 / Item 2)
or the switch below the handle (Fig. 2 / Item 3) is
pressed with the other hand.
Releasing any of the switches will bring the hedge
trimmer to a stop.
Please watch out for the cutters as they slow
down to a standstill.
-
Please check that the cutters work properly.
The twin-bladed cutters rotate in opposite direc-
tions, thus guaranteeing high cutting perfor-
mance and smooth operation.
-
Before use, fasten the extension cable in the
cable strain relief clip (see Fig. 4).
-
When working outdoors, use extension cables
that are approved for the purpose.
