Challenge Xtreme BMS210K.1, User Manual

Page: 10 / 16

HELPLINE NO 08707252949
10
3. BEVEL CUTS (SEE F1, F2))
Fig. F1
22
Fig. F2
A bevel cut is made at 0º miter and any
bevel angle in the range from 0º to 45º left.
The saw can be moved from the normal 0º
perpendicular position to an angled position
down to 45º from the horizontal, on the left
only. (See F1)
To adjust head tilt, release bevel lock knob
and tilt the saw head to the left, until the
desired angle is reached on the angle scale.
Re-tighten the bevel lock knob and make
your cut. (See F2)
4. COMPOUND ANGLE CUTS (SEE G)
Fig. G
By using both the rotary table adjustment
and the head tilt, cutting of compound
angles is possible. Fig.G shows the saw
with 45º set on the rotary table and the saw
head tilted 45º.
5. LASER GUIDE (See H)
25
Fig. H
The laser guide (21) equipped with this
machine is for the purpose of precision
cutting. Make sure the batteries are fitted in
the laser guide before carrying out precision
cutting. To fit the batteries, remove the
battery storage cover, insert 2 x 1.5V AAA
batteries, then replace cover.
Note: Ensure correct battery polarity.
To use the laser guide, simply slide the laser
on/off switch at the “I” position, the laser
guide then projects a visible red line on the
workpiece surface, make your cut along the
red line.
Switch off the laser after cutting.
Note: The sawdust may “block” the laser
beam, clean the laser generator periodically.
Warning: Never stare directly into the
laser beam and never point the beam
at anybody.
DANGER: Laser radiation. Avoid
direct eye contact with light source.
MAINTENANCE
Warning: Remove the plug from
the socket before carrying out any
adjustment, servicing or maintenance.
When all the adjustments, settings or
maintenance have been done, make sure
that all keys and wrenches have been
removed and that all screws, bolts and