HELPLINE NO 08454 505299
13
ORIGINAL INSTRUCTIONS
Remove the plug from the socket
before carrying out any
adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance. There are no
user serviceable parts in your power tool.
Never use water or chemical cleaners to
clean your power tool. Wipe clean with a
dry cloth. Always store your power tool in a
dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through
the ventilation slots. This is normal and will
not damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
GENERAL INSPECTION
Regularly check that all the fixing screws
are tight. They may vibrate loose over time.
REPAIRS
Only an authorized service centre should
replace the cordset or carry out other
repairs. If the cordset is damaged or worn,
have it replaced by an authorized service
centre.
POWER CORD MAINTENANCE
If the supply cord needs replacing, the task
must be carried out by the manufacturer,
the manufacturer’s agent, or an authorized
service centre in order to avoid a safety
hazard.
MAINTENANCE
TROUBLESHOOTING
•
If your sander will not operate, check the
power at the mains plug.
•
If the sander does not abrade surface,
checking the sanding paper. If the
sanding paper has been worn, replace
the new paper and try again. The paper
must be kept in a dry place, if it is
allowed to become damp, the abrasive
particles will lose their adhesion to the
backing paper and will not abrade.
•
If the sander does not move smoothly,
the sanding paper may be loose,
damaged or wrinkled. Replace and try
again.
•
If a fault can not be rectified return the
sander to an authorized dealer for repair.
