background image

  

  

11

10

  

  

Customer Helpline 

0845 450 5299

www.gardenservicecentre.co.uk

Customer Helpline 

0845 450 5299

www.gardenservicecentre.co.uk

Operating the Lawnmower 

Step 2 - Starting the Engine (continued)

2b Press the primer bulb (A) 3-5 times.

When starting a cold engine, press down the primer fully 3~5 times.

NOTE!

 The primer is a direct prime system so the primer bubble will not the fill with fuel, this is 

normal.

WARNING!

 Too much presses on primer may cause engine flooded.

When starting a warm engine, the primer does not need to be used. If the engine stops due to a 

lack of petrol, refill and press down the primer 3~5 times. 

2c Start/Stop Bar Activation

Pull the stop / start bar towards the upper handle.

2c Pull cord handle

With right hand, slowly but firmly pull the starter handle and rope from the pull cord guide  until 

you feel resistance, then pull briskly. If the engine fails to start after three pulls, repeat the start 
process. When the engine starts, return the starter rope to the pull cord guide gently.

NOTE!

 Clearing a flooded engine

If the engine won’t start after you have operated the starter several times, the engine may be 

flooded with excess fuel.

Use following procedure to clear and start a flooded engine.

A. Release the stop / start bar.
B. Remove the spark plug, dry it, and then reinstall it.

NOTE!

 install the spark plug carefully by hand, to avoid cross-threading. After the plug is seated, 

tighten 1/8 to1/4 turn with socket spanner of spark plug to compress the washer.
C. Pull the stop / start bar towards the upper handle. 
D. Operate the starter as described above.

2c

Operating the Lawnmower 

Step 3 - Mowing

WARNING!

 Always observe the strictest safety procedures when using the lawnmower.

Carefully read the safety instructions of this manual before using the lawnmower.
Start the engine and allow it run .See ”Step-2 Starting the engine”
To stop the engine, release the stop / start bar.

Keep a firm grip on the upper handle and walk, never run with the mower, be very careful when 

mowing uneven or rough ground. Mow across slopes, never up and down. Be careful when 

changing the direction of the mower on a slope. Do not use the mower on a steep slope of more 

than 15°.
The best result will be achieved if the grass is dry. Wet grass will tend to clog the blade and the 

grass collection system. Grass grows at different rates at different time of the year.

Never use the lowest cutting height for the first cut of the season or in drought conditions. Only 

about one thirds of the grass height should be cut.

If the lawnmower will not collect the cuttings efficiently, the grass discharge chute may be 

blocked. The grass bag may be full, or the underside of the mower deck may be clogged.

Engine start

Engine stop

Step 4 - Self-propelled

To get the mower to self propel press the self propel bar to the upper handle bar to the upper 

handle, the clutch for the drive will be closed and the lawnmower will start to move with the 

engine running. Release the self-propelled bar in good time to stop the moving lawnmower.

Practice starting and stopping until you are familiar with the propulsion control of the mower.

2b

A

Summary of Contents for 7305368
















Reviews: