5.1 Setting the cutting depth (Figure 2)
Undo the locking screw for setting the cutting
depth (4).
Set the cutting depth in accordance with the scale
(a).
When cutting wood or plastic the selected cutting
depth should be a little larger than the material
thickness.
To prevent damage to underlying surfaces, the
cutting depth can be set exactly to the thickness
of the material. However, this will result in a
slightly unclean cut.
5.2 Extraction of dust and chips (Figure 3)
Connect your tool to an extraction unit or vacuum
cleaner. This will provide excellent extraction of chips
and dust from the workpiece.
The benefits are that you will protect both the
equipment and your own health. Your work area will
also be clean and safe.
Attach the adapter for the dust extraction system
(11) to the connection for the dust extraction
system (10).
You can then connect a suitable vacuum cleaner
(not supplied) to the dust extraction system
adapter (11).
5.3 Parallel stop (Figure 4/5)
The parallel stop (9) enables you to saw parallel
lines.
Loosen the locking screw for the parallel stop (8)
on the saw foot (6).
To assemble, slide the parallel stop (9) into the
guide (a) on the saw foot (6) (see Figure 4).
Set the required spacing and then tighten the
locking screw (8) again.
Using the parallel stop: Position the parallel stop
(9) flat on the edge of the workpiece and start the
cut.
2
3
4
a
11
10
Helpline No 0844 801 8701 / IRE 189 094 6244
10
4
5
9
6
a
8
6
9
