32
FRESH WATER SYSTEM
Your RV is outfitted with a system designed to
provide fresh (potable) water service from an onboard
water tank or a city water connection with a fresh water
tank fill located on the outside of the trailer.
When connecting to the city water hookup, use only a
non-toxic water hose, available at most RV supply
stores. Since water pressures at campgrounds and
household hookups vary, you should install an inline
pressure regulator at the water supply faucet. This will
protect both the RV water system and supply hose
from excessively high water pressure.
CAUTION:
The pump is not equipped with a dry tank
shut-off switch. Turn the pump switch OFF if water in
tank becomes depleted or when system is not in use.
The pump operates when water pressure within outlet
plumbing drops below a predetermined pressure. A
drop in pressure occurs when a faucet or a toilet valve
is opened. When the faucet is closed the pump shuts
off as soon as the system is re-pressurized.
Turn the pump ON to pressurize the water system.
When the faucet is opened, the water may sputter for a
few seconds. This is normal and no cause for alarm.
The water flow will become steady when all air is bled
from the water lines. If a faucet is open slightly,
allowing water to flow slowly, the pump may pressurize
the plumbing faster than the water is released, causing
the pump to cycle on and off.
A built-in check valve prevents back flow and protects
the pump and fresh water tank from excessive city
water system pressures. The pump operates at 2.8
GPM and 45 PSI. At free flow the pump draws
approximately 4 amps. A fuse located in the power center
protects the water pump circuit.
When traveling, always turn OFF the water pump.
This will reduce the possibility of water flowing during
travel. If the pump cycles on and off when no water is
being used, you may have a partly open faucet, a leak
in the water system or an empty water tank.
Never attempt to service the pump without first turning
off the power and opening all faucets to relieve pressure
in the water system. Consult the installation and
operation manual for full details in the
Owner’s
Information Package.
WATER TANK FILL
The fresh water system should be sanitized at the
initial filling, after a period of storage or if contaminated.
Fill tank slowly. Do not overfill. Do not leave
unattended while filling. Structure damage may occur.
Filling the fresh water tank:
1.
Close water tank drain petcock located on the outside
of the water tank.
2.
Remove cap on fresh water fill inlet.
3.
Using a 3/8" hose adapter, fill the water tank
through the exterior fill spout slowly at a low
volume until water overflows out the vent. Do not
force water into spout since air in the tank must
be released during filling. Do not put the potable
water hose into the mouth of the fill use a
3/8" Plastic Hose Adapter For Filling Water Tank
4.
Set pump control switch to ON.
5.
Open each faucet one by one until water flows
evenly, and no air bubbles are evident.
6.
Top off water tank through the exterior fill spout to
replace water used in filling the water heater and
purging the water lines of air.
7.
Replace cap
CITY WATER INLET
It’s a good idea to purchase a pressure regulator to
protect your RV from possible damage due to
excessive water pressure.
To supply city water to your trailer’s water system and
bypass the water pump:
1.
Attach a potable water hose to the exterior city
water inlet connection.
2.
Pump switch should remain in OFF position.
3.
Open each faucet until water flows evenly.
Summary of Contents for TAKENA
Page 1: ...1...