CHAD-O-CHEF SMB-310, Assembly Instructions Manual

Page: 2 / 20

General Instructions and Safety notes
DO NOT begin assembly of your Sizzler Mobile Braai, until
you have read and understand the Assembly and Safety
Instructions fully.

Refer to the Sizzler Instruction Manual for assembly, maintenance
and further operating instructions of your Sizzler Gas Braai.

Remove ALL protective PVC film covering the unit before use
and only AFTER assembly is complete. As you could scratch the
surfaces during the assembly process.

The Sizzler Gas Braai associated with the Sizzler Mobile Cabinet
requires an operating pressure of 2,8 kPa at the appliance.

A suitable LPG regulator that complies with the requirements of
SANS 1237 must be installed with the Sizzler Gas Braai associated
with this product.
Important Information For the USER:
The ‘Sizzler’ Gas Braai associated with this appliance may only be installed
using the supplied Gas hose and Regulator by Chad-O-Engineering (Pty)LTD.
Note that if the guarantee card is not signed and returned to the manufacturer,
the product guarantee is invalid.
1
Warning:
If you already own a Chad-O-Chef Sizzler:
A qualified gas installer must replace the compression elbow
inlet on the manifold with the supplied hose-tail connector.
Only clean the unit with hot soapy water and never with
any abrasive materials.
Caustic Oven cleaners can fatigue stainless steel with rust.
Ventilation requirements:
This appliance is designed with ventilation holes in the front
and back of the unit. Take care and ensure that these
ventilation holes are not obstructed during use.
Do not fully cover the cooking area with a solid plate whilst
braai is on, this will result in component failure.
(This unit is not an oven)