EN - Module 1in -3out waterproof housing
(54750)
Install the module and housing :
1° On the cover plate loosen 4 supplied screws on each corner with a crosshead
screwdriver then remove the cover plate. (Note: 4 supplied screws will not drop
out from the cover plate).
2° Secure the Cable Gland (4 cable glands included ex-factory) at position where
the wires will be threaded through.
3° Connect AC wire and load (out door lamp) to receiver block terminal. Separate
AC wire and load (lamp) wire for each cable gland. Making sure AC wire and load
(lamp) wire are correctly installed.
4° Tidy up the wires and screw in the module.
5° Tighten the cable glands by turning clock wise.
6° After module and wires are in place, affix the housing to the wall or ground.
7° Link code (see Link Code).
8° Replace the cover plate then tighten the 4 screws on each corner with a
crosshead screwdriver. Module can be screwed in 8 different directions to suit
the running cables.
Install the transmitter.
Link Code :
1° Bring the transmitter near the receiver, push the module learning button once.
2° Module led will blink slowly, push the transmitter ON button.
3° Module connected lamp will blink twice, code is confirmed and led stops
blinking.
Delete a code :
1° Push the learning button on module once, led blinks slowly.
3° Push the transmitter OFF button of the transmitter.
4° Module connected lamp will blink twice, code is deleted and led stops
blinking. Repeat Link steps for re-setting.
Delete all memories :
1° Push the learning button on module for 6 seconds, led blinks.
2° Release and push again once.
3° Receiver connected lamp will blink twice, memory is erased and led stops
blinking.
* ALL PROGRAMMED MEMORY WILL BE DELETED.
Receiver has 6 memory settings :
Self program function receiver has 6 memory settings. It can be programmed as
to your requirement with special effect. It can be programmed to switch ON at
one time individually or programmed with different combinations switching.
This means one receiver can be programmed into max. 6 different combination.
Example : if there is 3 receivers (1. lamp shade, 2. night light, 3. fan). Receiver 1,2,3
can be control individually with transmitter button 1,2,3. Receiver 1,3 can be
programmed with transmitter button 4, (lamp shade and fan ON/OFF at same
time). Receiver 1,2,3 can also be programmed into group function ALL ON or OFF
at same time into group button (lamp shade, night light and fan ON/OFF at same
time)
Fault finding:
No activation : Check battery polarity or running out battery. Check code
program sucessful. Check the module fuse.
Caution:
Do not place two receivers near each other, the distance should be above 1
meter. Transmission distance can be reduced depending on wall thickness or
wireless environment.
Warning!
Disconnect main power before wiring installation and fuse changing.
DO NOT OVERLOAD.
www.chac
POCFt%FDMB
ra
UJPOT$&t
Hereby CHACON declares that the device is in conformity with the essential requirements
and the other relevant disposals of the directive 1999/5/CE.
IMPORTANT (Directiv
F&$
WEEE) :
During the sorting of your waste, we ask you to respect the
regulations in effect regarding their elimination.
We thank you for depositing them in a place allowed to
this purpose and respecting the environment.
