3
Introduction for buttons on remote controller
FAN button
SWING button
3
4
Pressing this button can set fan speed circularly as: auto (AUTO), low( ),
medium
( ), high( ).
Auto
Note:
● Under AUTO speed, air conditioner will select proper fan speed automatically
according to ex-factory setting.
● Fan speed under dry mode is low speed.
Press this button can select up&down swing angle. Fan blow angle can be selected
circularly as below:
● When selecting " ", air conditioner is blowing fan automatically
. Horizontal
louver will automatically swing up&down at maximum angle.
● When selecting "
、
、
、
、
● When selecting "
、
、
● Hold " "button above 2s to set your required swing angle. When reaching your
required angle, release the button.
Note:
"
、
、
" may not be available. When air conditioner receives this signal, the
air conditioner will blow fan automaticall
y.
no display
(horizontal louvers stops
at current position)
temperature. Press "FAN" button to adjust fan speed. Press "SWING" button to
adjust fan blowing angle. (Cooling only unit won’t receive heating mode signal. If
setting heat mode with remote controller, press ON/OFF button can’t start up the
unit).
Note:
● For preventing cold air, after starting up heating mode, indoor unit will delay 1~5
minutes to blow air (actual delay time is depend on indoor ambient temperature).
● Set temperature range from remote controller:
60.8~86°F (16~30°C)
; Fan
speed: auto, low
speed, medium speed, high speed.
