MAINTENANCE
Make certain that the unit is disconnected
from power source before attempting to
service or remove any component.
Cleaning
• Keep machine and workshop clean. Do not allow sawdust to
accumulate on the tool.
• Keep the drums clean. Dirt on drums will cause poor tracking
and belt slippage.
• Operate tool with dust collector to keep dust from
accumulating.
After sanding wood or non-metallic
material, always clean dust collector and
guards of sawdust before grinding metal. Sparks could
ignite debris and cause a fire.
• Be certain motor is kept clean and is frequently vacuumed free
of dust.
• Use soap and water to clean painted parts, rubber parts and
plastic guards.
Lubrication
• The shielded ball bearings in this tool are permanently
lubricated at the factory. They require no further lubrication.
• When operation seems stiff, a light coat of paste wax applied to
the belt table and disc table will make it easier to feed the work
while finishing.
• Do not apply wax to the belt platen. Belt could pick up wax and
deposit it on wheels causing belt to slip.
Keep Tool In Repair
• If power cord is worn, cut or damaged, have it replaced
immediately.
• Replace worn abrasives when needed.
• Replace any damaged or missing parts. Use parts list to order
parts.
• Any attempt to repair motor may create a hazard unless repair
is done by a qualified service technician.
7
