CGOLDENWALL B00JMEBB2Q, Manual

Page: 22 / 24

21
Trouble Shooting
Trouble Cause Elimination method (*Please cut
off the power when doing
following)
The machine does not
operate after power on
Poor contact between the plug and
socket
Please plug in the power cord and
check whether the power indicator
lights is on.
If the indicator does not light, then
the power cord is faulty.
Poor contact between the lid and
induction switched
Adjust the position of the screws
on both sides of the lid in advance
so that they can trigger the
induction switches in the ears
when close the lid.
Air over-load protector protecting Press the air over-load protector to
restart
Carbon brush ware out Change the carbon brush
Motor run slowly,or not
runs, even vibrates,
making noise
Stuck inside of crush cabin by
material, or foreign subject
Remove the stuck stuff
Low power voltage Insert the plug directly into the
wall socket instead of the terminal
block. Then try another place to
see if the machine can be turned
on.
Motor cabin over heat
Over load capacity Reducing the amount of grinding
and decreasing the working
pressure
Material not dry enough Dry the material in the sun or bake
it.
Low power voltage Insert the plug directly into the
wall socket instead of the terminal
block. Then try another place to
see if the machine can be turned
on.
Spark on the carbon
brush surface
carbon brush is not smooth Change the carbon brush