9600 SERIES ANALOG USER GUIDE
www.telematrix.net
9
INSTALLING BATTERY INTO HANDSET
1 . Open cover with small screwdriver . Do not
open more than half-inch .
2 . Grip handset and depress cover at hinged end .
3 . Slide cover off, exposing battery compartment .
4 . Slide battery plug into receptacle, matching
up slot and opening on receptacle .
5 . Slide battery into battery compartment .
Do not force battery!
6 . Press on back end of battery to snap into
place .
7 . Place hinged end of cover into slot, then
press down and snap into place .
Syncing Handset
REGISTERING DECT HANDSET WITH A
SPECIFIC BASE UNIT
1 . Place handset into base (or charging
station) for 10 minutes before attempting
the handset sync procedure . This gives the
battery enough charge to complete the sync
process .
2 . Remove DECT handset from base unit cradle .
3 . Press and hold down the LOCATE button on
the base for approximately 10 s .
4 . When the button has been held down long
enough, the In-Use or Charge indicator on
the base unit begins to blink (even though
there isn’t a handset in the cradle) .
5 . While the In-Use or Charge indicator
is blinking, press steadily “*” (star key)
on the handset until the beep is heard
(approximately 10 s), continue to hold down
the “*” (star key) until you hear a second
beep . The handset is now registered to this
base unit .
6 . If you hear three short beeps this means
that the handset failed to register .
Simply press the LOCATE button on the base unit .
See Phone Map . The handset will beep for about
15 seconds . Once the handset is located, press the
ON/OFF key to activate your handset .
REDIAL KEY
The REDIAL key is used to automatically redial the
last number manually dialed from the numeric
dial pad on the base or handset .
Simply engage telephone by pressing handset Line
1 or Line 2 ON/OFF key—or Line 1 or Line 2 key on
the base ON/OFF key, then press REDIAL button
on handset or base to dial last number dialed .
Note:
You may have up to three cordless handset
charging units operating off one DECT base unit .
Handset Battery
CHARGING THE HANDSET BATTERY (ON
BASE AND CHARGING STATION)
The handset Battery is a Ni-MH battery . This
battery requires a full charge prior to use to
ensure long life . To charge the battery, complete
the installation procedure by plugging the power
source into the wall outlet and the telephone base
or charging station .
Install the battery the battery per below
instructions, inserting battery plug into receptacle .
Place battery into opening in handset, press into
place, then replace cover and place handset into
base face down or charging station face front .
BATTERY LIFE WHEN COMPLETELY
CHARGED
Talk time:
7 .5 hours
Standby (handset off hook): 6 days
Charge for 24 hours to ensure a fully charged
battery .
www.telematrix.net
9700 SERIES ANALOG USER GUIDE
9
