6. Put the assembly plate with its recesses for the
screws face-up into the assembly aid.
7. Put the cylinder with the shaft first into the assembly
plate.
Make sure that the cylinder aligns with the
assembly plate. To do so, you can use the optionally
available assembly aid, or you can place the cylinder
together with the mounting plate e.g. onto the
edge of a table.
8. First, tighten
gently
the two socket head screws on
one side of the assembly plate. Then tighten the two
screws on the other side with 2 Nm. Then, also
tighten the screws on the first side with 2 Nm.
9. Put the plastic bearing ring onto the cylinder shaft.
The hole of the ring has to match the shaft
diameter of the cylinder. If the bearing ring does not
fit around the shaft, or if there is a certain
clearance, please contact your supplier.
10. Press the driver pin through the hole in the shaft
and hold on to it so that it cannot slip out of the hole.
CESeasy motor cylinder
Page 13 of 53
5 Mechanical cylinder for the motor cylinder
