CES SUPPORT 407-679-9440
Page 15
MAN71© CES 2010
Repeat Mode Enable (46#)
This programming code enables the repeat mode. The repeat mode allows receive audio to be passed to a transmitter
for mobile to mobile communications. This mode should only be enabled if the receiver and transmitter are
independent of each other. This will not work on a Push to Talk/Release to Listen transceiver.
0 = off
1 = on
Example: To enable the repeat audio function enter the following sequence: 46# 1#
Roger Beep (47#)
The 4700 provides a short audible beep into the telephone line each time the mobile user un-keys. This gives an
audible indication to the telephone party that they may now begin to talk.
0 = off
1 = On
Example : To enable courtesy beep function enter the following sequence: 47# 1#
Toll Restriction on speed dial location (48#)
Speed call locations can be toll restricted by enabling this command. When enabled, this will prevent dialing of
digits entered in the toll restrict locations.
0 = no
1 = yes
Example: To disable this feature enter the following sequence: 48# 0#
CW ID Interval (49#)
The CW ID feature can be programmed to transmit the Station Identification at pre-programmed CWID Time
Interval, connect, connect & interval time, disconnect, interval time & disconnect, connect /disconnect, interval time
& connect / disconnect, or it may be disabled. The CW ID will not be transmitted if the system is busy.
0 = off
1 = timer
2 = connect
3 = timer & connect
4 = disconnect
5 = timer & disconnect
6 = connect/disconnect
7 = timer, connect/disconnect
Mode of Operation (50#)
The model 4700VP can operate in three different modes; Half Duplex, Simplex Sampling or Simplex with
VeraTec™
Smart Sampling.
Half Duplex
In Half Duplex the 4700VP will keep the transmitter keyed for the duration of the call. When programmed for half
duplex operation it must be installed on a repeater or two radios using different frequencies.
Simplex Sampling
In the Simplex Sampling mode the 4700VP will sample at the programmed rate looking for a mobile carrier. If there
is a carrier present it will stay in the receive mode until carrier goes away. If the carrier is not present, the 4700VP
will go back to transmit mode until the next sample interval.
Simplex with VeraTec™ Smart Sampling
In the Simplex mode with VeraTec™
,
(CES proprietary smart sampling protocol), the 4700VP mixes Vox and
Sampling modes. When audio is present on the telephone line, the 4700VP will operate in Vox mode until the
maximum Vox timer ends. The maximum Vox timer controls how long the 4700VP will stay keyed continuously.
The unit will then enter sampling mode allowing the mobile operator to take control of the unit. This feature is very
