SmaRT Console Box Remote
U093.3.0
12
2.8
Proportional Output Lever and Joystick Adjustments
What You Need to Know for Output Minimum (Min) and Maximum (Max) Adjustments
Caution
If the base unit is wired to the machine, machine movement will occur
during these procedures.
Keep in mind at all times that you are going to control a moving piece
of machinery. You must strictly adhere to the safety instructions
described in this manual
’s Cervis, Inc. Safety Precautions.
•
Before performing dynamic Min and Max adjustments, make sure the area around the
controlled machine is safe to operate.
•
Power the base unit for dynamic adjustment.
•
Make sure the base unit LEDs are close enough to be easily read.
•
Observe the base unit LEDs while performing Min and Max adjustments.
•
Adjust Mode timeout defaults to a ten-second window of opportunity, where the unit returns
to normal operating mode if none of the switches are operated within the ten-second
window. The timer resets to ten seconds each time a lever or joystick is operated while in
Adjust Mode.
•
Adjust each Pulse Width Modulation (PWM) lever or joystick using the following steps.
Each lever or joystick direction can be independently adjusted.
Figure 6. Enter Lever or Joystick Adjust Mode (Standard Base Unit)
2.8.1 Enter Adjust Mode for Standard Base Unit PWM Outputs
1. Release the Stop switch (twist-up or pull-up) and flip the ON/OFF switch (S12)
UP.
2. Enter Adjust Mode by holding the Adjust Mode switch (S14) UP (first) and the
Associate switch (S13) DOWN while watching the standard base unit LEDs.
Adjust Mode is indicated when the bottom three LEDs 6, 7, and 8, begin flashing
(Figure 6).
3. Release switches the Adjust Mode and Associate switches (S14 and S13). LEDs
6, 7, and 8 go out; then LED 8 lights solid (Figure 6). This indicates that you are
in Adjust Mode.
Note
:
To abandon Adjust Mode at any time, hold switches the Adjust Mode and Association
switches (S14 and S13) DOWN.
Caution!
Be aware of lever or joystick activation during this process. Base
unit outputs may be active or activated during the adjustment
process.
About
4-seconds
S12
S13
S14
After S14,
S13 release
S14 S13 S12